User manual SONY BKM-FW50

[. . . ] 7 Assigning a fixed IP address to the BKMFW50 . The software specifications of this unit are subject to change for improvements without notice. â· Screens shown by application software may differ slightly from the illustrations shown in this manual. â· For safety, connect the port of this unit only to a network where there is no danger of excessive voltage or voltage surges. [. . . ] Turn power to the display on and wait for about 30 seconds. Using the menu of the display, assign one of the IP addresses that you have prepared beforehand (the one to be used for the display control function), as follows. 2) Use the M/m buttons or the numeric buttons on the remote control to enter a three-digit number (0 - 255). When you press the ENTER button or the , button, the cursor moves to the next field on the right. Enter the IP address that was assigned to the display control function into the address field, in the format "http://xxx. Then press the Enter key on the keyboard. when a user name and password have been set , the "Network Password" screen appears. Enter the user name and password that were set, and then proceed to the next step. This screen lets you set up the Network Password. The factory default settings are as follows: Name: root Password: fw50ad Click the "Network" button. under "Internet Protocol (TCP/IP)" , click "Specify an IP address". Then enter the IP address for the still image/video playback function in the input fields. If you set up the display as described below, an IP address can be assigned automatically by a DHCP server on the network. Turn power to the display on and wait for about 30 seconds. Next, assign an IP address to the still image/video playback function. You can make various display settings on the screen of the computer. Make sure that the BKM-FW50 is properly installed in the display, and that the BKMFW50, computer, and router or hub are properly connected with network cable. Then turn on power to the display, the computer, and the router or hub. When an IP address has been automatically assigned, you can call up the display control screen of the BKM-FW50 as follows and check which IP address has been assigned. The IP address changes each time power to the display is turned on. Therefore you must check the IP address as described here every time after turning power to the display off and on again. Enter the IP address that was assigned to the display control function into the address field, in the format "http:// xxx. [. . . ] connect PC Select this to enable the PC Presentation function of the BKM-FW50. The following items also need to be set. If the resolution selected here differs from the computer's actual resolution, the screen will not display at the proper size. When you click this button, the desktop screen of the computer at the specified IP address appears on the display. [. . . ]