User manual SONY BM-C110

[. . . ] If persons other than licensed contractors transport or dismount the TV, it may fall and cause injury or property damage. Be sure that two or more persons carry or dismount the TV. Do not lean on or hang from the TV as it may fall on you and cause serious injury. Be sure to use the supplied screws and attachment parts properly following the instructions given in this instruction manual. [. . . ] lCD color TV XBR-60LX90s* , KDL-60LX90s*/60NX80s* XBR-52LX90s* , KDL-52LX90s*/52NX80s* XBR-46LX90s* , KDL-46NX80s*/46NX70s* XBR-40LX90s* , KDL-40LX90s*/40NX80s*/40NX70s* This Wall-Hanging Bracket is designed for use with the products specified above. For other TVs, refer to their operating instructions to verify that the Wall-Hanging Bracket can be used. * In the actual model names, the "s" indicates numbers and/or characters specific to each model. If the following precautions are not observed, injury or property damage may occur. Do not install the Wall-Hanging Bracket on wall surfaces where the corners or the sides of the TV protrude away from the wall surface. Do not install the Wall-Hanging Bracket on wall surfaces such as a pillar, where the corners or the sides of the TV protrude away from the wall surface. If a person or object happens to hit the protruded corner or side of the TV, it may cause injury or property damage. do not install the TV over or under an air-conditioner. If the TV is exposed to water leaks or air current from an air conditioner for a long time, it may cause a fire, an electric shock or a malfunction of the TV. be sure to tighten the screws securely in the designated position. If you fail to do so, the TV may fall and cause bodily injury to someone or damage to the TV. WARNING The wall that the TV will be mounted on should be able to support a weight of at least four times that of the TV. (Refer to your TV's operating instructions for its weight. ) Determine the strength of the wall the TV will be mounted on. Make four holes at the marks on the Paper Template M using an electric drill. A For thick walls Make holes 65 mm (2 5/8 inches) deep in the wall using a 9 mm (3/8 inches) electric drill. Make holes only in the superficial area of the wall using a 13 mm (17/32 inches) electric drill. Peel the Paper Template M from the wall, and secure the Wire Bracket A to the wall. B For thin walls 1 Insert the Anchors B H with the metal parts turned towards the holes of the wall. 2 Pull the Anchors B H and confirm that they do not come out from the wall. 3 Push the cap of the Anchor B H into the wall. 4 Shift the upper and lower tips of the Anchor B H to the front and back, and then stretch the two handle pieces up and down until they touch the wall. [. . . ] * In the actual model names, the "s" indicates numbers and/or characters specific to each model. Fixez une rondelle A K à chaque poulie B, puis fixez deux rondelles B L respectivement au support inclinable C et au support de courroie D. Si vous utilisez le système Home Cinéma HT-CT350 Fixez également les rondelles restantes à chacune des rondelles déjà fixées respectivement aux deux poulies, au support inclinable et au support de courroie. Om produkterna emellertid används felaktigt kan det leda till allvarliga personskador till följd av brand, elstötar eller av att produkten vält eller fallit ned. [. . . ]