User manual SONY CA-TX50

[. . . ] 4 Location and Function of Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Front and Right Side . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Switches and Knobs on the Rear . . . . . . . . . . . . . . . . . . . . . . . . 6 Connectors and Switches on the Rear and Left Side . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] H-POSITION: Adjusts the horizontal position of the box cursor. V-POSITION: Adjusts the vertical position of the box cursor. WIDTH: Adjusts the width of the box cursor. HEIGHT: Adjusts the height of the box cursor. f PROD/ENG (producer/engineer select) switch Selects the channel for transferring intercom audio. ENG: Uses the engineer line. Note b TALLY switch Set this switch to the ON position to activate the back tally indicator c. c Back tally indicator When the TALLY switch b is in the ON position, this indicator lights in response to this unit's operating status. During recording, this indicator lights in red. It also lights when the CALL button on the camera control unit or remote control panel has been pressed. When the INCOM selector on the CCU-TX50/50P Camera Control Unit is in the PRIV position, the intercom operates only between the camera and the 6 Location and Function of Parts camera control unit regardless of the PROD/ENG switch position. g PROGRAM knob Adjusts the program audio reception level. When using a DXC-D50 series camera, setting the MIC/ LEVEL switch i to OFF/FRONT will enable this knob to adjust the balance between the program audio and intercom audio levels. Turn clockwise to raise the program audio level, and turn counterclockwise to raise the intercom audio level. h INTERCOM knob Adjusts the intercom audio reception level. Setting the MIC/LEVEL switch i to OFF/FRONT will enable the audio level knob on the DXC-D50 series camera's front panel to adjust both the intercom audio and program audio levels. Note If you switch the position of the MIC/LEVEL switch i, settings of the program audio reception level and intercom audio reception level are changed. Adjust them again using the PROGRAM knob g and INTERCOM knob h. i MIC/LEVEL switch Decides the on/off of the intercom microphone and the adjusting method of the reception level. ON/REAR: Sets the intercom microphone to on. The reception level is adjusted using the INTERCOM knob. OFF/REAR: Sets the intercom microphone to off. The reception level is adjusted using the INTERCOM knob. [. . . ] Otherwise the screws may not be properly fixed. Do not cover with cloth While the unit is in operation, do not cover it with a cloth or other material. This can cause the temperature to rise, leading to a malfunction. Removing from the camera Follow the procedure above in reverse. After use Turn the POWER switches on the unit and camera control unit off. Care If the body of the unit is dirty, wipe it with a dry cloth. For severe dirt, use a soft cloth steeped in a small amount of neutral detergent, then wipe dry. Do not use volatile solvents such as alcohol or thinners, as these may damage the finish. Notes on Use 11 Specifications General Power requirements When supplied via the CCU connector: 180 V DC When supplied via the DC IN connector: 12 V DC (10. 5 to 17 V DC) Power consumption When 180 V DC is supplied via the CCU connector: max. [. . . ]