User manual SONY CAV-M1000ES

[. . . ] 4-253-728-11(2) Custom Integrated AV System Installation Manual Owner's Record The model and serial numbers are located on the rear panel. Record the model and serial numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Serial No. CAV-M1000ES 2004 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] "INPUT IR CODE" appears for a few seconds, then the display window changes to "CODE ID #81 R r" when you select SOURCE in step 3, and changes to "CODE ID #110R r" when you select COMMON. While the code ID number is displayed in the display window, press the corresponding button on the remote control of the component while pointing it toward the learning IR window of the Main Unit. When your entries are confirmed, "COMPLETED!" appears for a few seconds, then the display window moves to the next remote code entry. If your entries are not confirmed, "LEARN FAILED!" appears for a few seconds, then the failed code ID number appears. Tips · When you want to skip the code ID number, press the r cursor. · When you want to re-enter the code ID, press the R cursor. 5 22US . . . Testing Learned Remote Code ­ CHECK Mode You can check to see if the remote code of the source component have been successfully learned by the Main Unit. Customizing the Main Unit ­ INSTALLATION Mode Viewing disc information ­ DISC SEARCH By connecting a Sony DVD Mega Changer to an RS232C jack, or a Sony CD Mega Changer to CONTROL A1II, you can view disc information, such as a disc title. 1 2 Press SOURCE SELECT +/­ to select the source component that you want to check. Press MODE repeatedly until "<<CHECK>>" appears in the display window, then press ENTER. "SET COMMAND" appears for a few seconds, then some of the learned remote codes appear in the display window. Press the R cursor or r cursor repeatedly to select the remote code that you want to check (ex. The selected remote command will be performed. Setting up the Main Unit 1 2 Turn off the power. Press and hold MODE and the T cursor simultaneously, and then turn on the power. "DISC SEARCH" appears in the display window for a few seconds, then, "DVD MEGA" appears. Press the R cursor or r cursor to select "DVD MEGA" or "CD MEGA". "SEARCHING NOW. . . " appears and flashes while the Main Unit is searching for the disc information. "COMPLETED!" appears after the information has been received, and a DVD Mega Changer or a CD Mega Changer turns off automatically. "FAILED!" appears when information is not found or cannot be read. The display returns to the NORMAL mode. 3 3 4 4 5 23US Customizing the Main Unit ­ INSTALLATION Mode Adjusting the source input offset ­ SOURCE INPUT OFFSET You can keep the volume balance among source components by taking an average of the output level from each source component. Locking the settings ­ SETUP LOCK You can lock in the settings under which have been entered into the Main Unit. 1 2 Turn off the power. Press and hold ZONE + and ALL ZONE MUTING simultaneously, and then turn on the power. "SOURCE OFFSET" appears in the display window for a few seconds. Press the R cursor or r cursor repeatedly to select a source number. Each time you press the R cursor or r cursor, the display window changes cyclically as shown below. SOURCE OFFSET (Appears for a few seconds) r 1 2 Turn off the power. Press and hold SOURCE SELECT + and BACK simultaneously, and then turn on the power. [. . . ] To cancel the muting, press MUTING again or VOLUME +. 1 Press SELECT next to the desired source displayed in the LCD window. Press any of the following buttons to control the activated source component. H: Operates the selected source component. . />: Locates a specific track or preset station. 2 IR sensor Receives IR signals from the IR Remote Control for Keypad (supplied). Display window Shows the selected source, zone volume level, zone and system status, and other system status information. [. . . ]