User manual SONY CCD-TR614

[. . . ] the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. [. . . ] Select to deactivate the Remote Commander to prevent your camcorder from responding to a command sent by another VCR remote control unit. The setting returns to [ON] when you have the power source disconnected from your camcorder for more than 5 minutes. GON OFF Select to turn on the camera recording lamp on the front of your camcorder during recording. Select this setting in the following recording situations. The camera recording lamp will not light up during recording. When you do not want the subject to be nervous about being recorded. When you are recording close to the subject. When the subject reflects the recording lamp. For TRV270E/285E: You can select up to 20 scenes (programs) and record them in the desired order to another recording device such as VCR (p. You can create a copy of the picture recorded on your camcorder on other recording devices (p. For TRV285E, you can also record the picture from a VCR to a tape on your camcorder (p. Step 1: Preparing your camcorder and VCR for operation Follow the steps below when you are performing the Easy Dubbing for the first time. You can skip this setting if you have set up the VCR by the following procedure before. b Note · You cannot perform the Easy Dubbing on a VCR that does not support [IR SETUP] codes. Turn the SEL/PUSH EXEC dial to select [IR SETUP], then press the dial. When you connect with an A/V connecting cable, you need to check the [IR SETUP] code signal to see if your VCR can be operated by your camcorder (infrared ray emitter). Turn the SEL/PUSH EXEC dial to select the [IR SETUP] code of your VCR, then press the dial. When there is more than one code listed for the manufacturer of your VCR, try each code and find the most appropriate one. Connect your VCR to your camcorder as a recording device (p. Turn the SEL/PUSH EXEC dial to select [PAUSE MODE], then press the dial. Turn the SEL/PUSH EXEC dial to select the mode to cancel recording pause on the VCR, then press the dial. Camcorder towards the remote sensor on your VCR, from about 30 cm (12 in. [. . . ] Procedures Connect your camcorder to a wall socket using the supplied AC Adaptor, and leave it with the POWER switch set to (CHG) OFF for more than 24 hours. Do not add excessive pressure on the LCD screen, as it may cause damage. If your camcorder is used in a cold place, a residual image may appear on the LCD screen. While using your camcorder, the back of the LCD screen may heat up. [. . . ]