User manual SONY CCD-TR910

[. . . ] You will soon be producing home video that you can enjoy for years to come. To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS1362 (i. [. . . ] Press the ­ (OE) side momentarily, the last few seconds of the recorded portion plays back (Rec Review). Hold down the ­ side of EDITSEARCH until the camcorder goes back to the scene you want. the last recorded portion is played back. To go forward, hold down the + side (Edit Search). Re-recording begins from the point you released EDITSEARCH. Provided you do not eject the cassette, the transition between the last scene you recorded and the next scene you record will be smooth. Connect the camcorder to your VCR or TV to watch the playback picture on the TV screen. It is recommended to use the mains as the power source (p. Open the jack cover and connect the camcorder to LINE IN on the VCR by using the supplied A/V connecting cable. Open the jack cover and connect the camcorder to your TV by using the supplied A/V connecting cable. You can monitor the playback picture in the viewfinder. notes on the POWER lamp · The POWER lamp will remain lit for a while even if the unit is unplugged after use. If the POWER lamp does not light, disconnect the power cord. after about one minute , reconnect the mains lead. To remove the adaptor The adaptor is removed in the same way as the battery pack (p. (2) Insert six new alkaline batteries into the battery holder, following the marking on the holder to be sure the batteries are installed in the correct direction. (3) Insert the battery holder with the alkaline batteries. (4) Insert the battery case with the alkaline batteries to the battery mounting surface of the camcorder in the same way as the battery pack. The battery life may be shorter depending on the storage condition of the battery before being purchased and temperature. You may not use the battery case in cold environment. The battery case is removed in the same way as the battery pack (p. When you replace the batteries, be sure to remove the battery case from the camcorder to prevent malfunction. [. . . ] When the CHARGE lamp flashes again Installanotherbatterypack. When the CHARGE lamp does not flash again If the CHARGE lamp lights up and goesoutafterawhile, thereisno problem. When the CHARGE lamp flashes again TheproblemiswiththeACpower adaptor. When the CHARGE lamp does not flash again If the CHARGE lamp lights up and goesoutafterawhile, theproblemis withthebatterypackinstalledfirst. [. . . ]