User manual SONY CCD-TRV101E

[. . . ] Before operating the unit, please read this manual thoroughly, and retain it for future reference. To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. [. . . ] (1) While the camcorder is in standby mode, keep pressing the + (forward playback) or ­ (reverse playback) side of EDITSEARCH, and release the button where you want to end the insertion [b]. (3) Keep pressing the ­ side of EDITSEARCH and release the button at the point where you want to start the insertion [a]. Re-recording a picture in the middle of a recorded tape Note on re-recording The picture and the sound may be distorted at the end of the inserted portion when it is played back. Set the ORC TO SET in the menu to automatically adjust the recording condition of the tape to get the best possible recording. "ORC" blinks for about 9 seconds on the LCD screen. If you have already performed this function, "ORC ON" is displayed when you select ORC TO SET in the menu system. When you set ORC TO SET, the recording on the tape is erased for about 0. 1 second so that the camcorder can check the tape condition. Be careful when you use a recorded tape. 1 second blank is erased if you record from the point where you set ORC TO SET for more than 2 seconds, or if you record over the blank. You cannot set ORC TO SET for a cassette with its tab out (red). Procedure to play back is the same as when playing back on the LCD screen. While playing back on a TV screen, close the LCD panel to reduce noise during various playback. If you are going to connect the camcorder using S video cable (not supplied) [a], you do not need to connect the yellow (video) plug of the A/V connecting cable [b]. Ç : Signal flow / Flujo de señales If your VCR is already connected to a TV Connect the camcorder to the LINE IN inputs on the VCR by using the A/V connecting cable. If your TV or VCR is a monaural type Connect the yellow plug of the A/V connecting cable for video to the TV or VCR. Connect only the white or red plug for audio to the TV or VCR. If you connect the white plug, the sound is L (left) signal. If you connect the red plug, the sound is R (right) signal. Monitoring the picture from a TV or VCR You can monitor the picture on the LCD screen. You can search for the boundary between recording dates using the Data Code automatically recorded on the tape. there are two modes: · Searching for the beginning of a specific date, and playing back from there (Date Search) · Searching for the beginning of all days, one after another and playing back about 10 seconds of each (Date Scan) Each time you press DATE SEARCH, the mode changes as follows: Date Search Date Scan Nothing To search for the beginning of a specific date (3) When the current position is [b], press 0 to search towards [a] or press ) to search towards [c]. [. . . ] ) when converted into a 35 mm still camera) F 1. 7 oz) Design and specifications are subject to change without notice. 2 W during camera recording using the LCD screen Operating temperature 0°C to 40°C (32°F to 104°F) Storage temperature ­20°C to +60°C (­4°F to +140°F) Dimensions Approx. When you connect an external microphone, you cannot set WIND in the menu system. [. . . ]