User manual SONY CCD-TRV15E

[. . . ] Before operating the unit, please read this manual thoroughly, and retain it for future reference. Congratulations on your purchase of this Sony Handycam VisionTM camcorder. With your Handycam Vision you can capture life's precious moments with superior picture and sound quality. Your Handycam Vision is loaded with advanced features, but at the same time it is very easy to use. [. . . ] note You can not enter over 20 characters title. If you take 5 minutes or longer to enter characters while a cassette is in the camcorder The power goes off automatically. Turn STANDBY down once and then up again, then proceed from step 1. In step 4, turn the control dial to select [M] then press the dial. Repeat this step until all characters are deleted. Re-recording a picture in the middle of a recorded tape ⭠CCD-TRV69E only You can insert a scene in the middle of a recorded tape by setting the starting and ending points. Re-recording a picture in the middle of a recorded tape (1) While the camcorder is in Standby mode, keep pressing the + (forward playback) or ­ (reverse playback) side of EDITSEARCH, and release the button where you want to end the insertion [b]. (3) Keep pressing the ­ side of EDITSEARCH and release the button at the point where you want to start the insertion [a]. Re-recording a picture in the middle of a recorded tape notes on re-recording · The picture and the sound may be distorted at the end of the inserted portion when it is played back. ⷠIf you re-record on the portion which contains non-recorded section, the zero memory function may not work correctly. ⷠWhen the START/STOP MODE switch is set to , you cannot use the zero memory 5SEC or function. Before you start recording or during recording, press DATE or TIME. You can record the date or time displayed in the viewfinder or on the LCD screen with the picture. press DATE (or TIME) , then press TIME (or DATE) to display the date and time together. The clock is set at the factory to London time for United Kingdom and to Paris time for the other Europian countries. Use this feature to check the tape condition before recording, so that you can get the best possible picture (ORC). The camcorder takes about 5 seconds to check the tape condition and then returns to Standby mode. Each time you insert the cassette When you set ORC TO SET, the recording on the tape is erased for about 0. 1 second so that the camcorder can check the tape condition. Be careful when you use a recorded tape. 1 second blank is erased if you record from the point where you set ORC TO SET for more than 2 seconds, or if you record over the blank. ⷠYou cannot use this function on a tape with the red mark on the cassette exposed. [. . . ] 8 oz) excluding mains lead Design and specifications are subject to change without notice. 23) Make sure that the length of the tripod screw is less than 6. 5 mm (9/32 inch) otherwise, you cannot attach the tripod securely and the screw may damage the camcorder. % Microphone Note on the intelligent accessory shoe ­ CCD-TRV65E/TRV69E only Supplies power to optional accessories such as a video light or microphone. [. . . ]