User manual SONY CCD-TRV94E

[. . . ] Before operating the unit, please read this manual thoroughly, and retain it for future reference. Congratulations on your purchase of this Sony Handycam VisionTM camcorder. With your Handycam Vision you can capture life's precious moments with superior picture and sound quality. Your Handycam Vision is loaded with advanced features, but at the same time it is very easy to use. [. . . ] When the desired title appears, wait for it to stop flashing. Each time a new title appears, it is flashing. (2) When the desired title appears, wait for it to stop flashing, and press TITLE again to erase the title from the display. (3) Press START/STOP to start recording. (4) When you reach the point where you want to add the title, press TITLE. The titles are displayed in the language you selected in the menu system. notes on superimposing a title · If you have not made any original titles, they are not displayed. ⷠYou cannot select a title while you are recording. ⷠFADER does not work while the title is displayed. ⷠYou cannot simultaneously record the title and the date or time. ⷠYou cannot record the title during fade-in/ fade-out. ⷠIf you display the menu while superimposing a title, the title is not recorded while the menu is being displayed. You can chose from the following 7 colours: WHITE ~ YELLOW ~ VIOLET ~ RED ~ CYAN ~ GREEN ~ BLUE (4) Press MENU to erase the menu display. You can make up to two titles and store them in the camcorder. we recommend to eject the cassette before you begin. Your title can have up to 22 characters. (3) Turn the control dial to select the desired character, then press the dial. (4) Repeat step 3 until you finish the title. (5) When you are finished, turn the control dial to select , then press the dial. In step 2, select TITLE1 SET or TITLE2 SET, depending on which title you want to edit, then change the title. To move the cursor to the character on the left side, select M. If you enter 22 characters in step 4 The title is stored immediately (and you can skip step 5). [. . . ] ) On-screen display TN LCD/TFT active matrix method Total dot number 112, 086 (479 x 234) Input and output connectors S video output/monitor input 4-pin mini DIN Luminance signal: 1 Vp-p, 75 ohm, unbalanced Chrominance signal: 0, 3 Vp-p, 75 ohms, unbalanced Video output/monitor input Phono jack, 1 Vp-p, 75 ohm, unbalanced Audio output/monitor input Phono jacks (2: stereo L and R) 327 mV, (at output impedance 47 kilohm) impedance less than 2. 4 V (AC power adaptor) Average power consumption During camera recording using LCD: 5. ) 560 g (1 lb 3 oz) Design and specifications are subject to change without notice. 21) Make sure that the length of the tripod screm is less than 6. [. . . ]