User manual SONY CCD-FX240

[. . . ] You will soon be producing home video that you can enjoy for years to come. To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS1362 (i. [. . . ] The characters you have entered remain stored in memory. Set the POWER switch to OFF (CHARGE) once, and turn it to CAMERA again, then proceed from step 1. We recommend setting the POWER switch to PLAYER or removing the cassette so that your camcorder does not automatically turn off while you are entering title characters. Skjut POWER först till läger OFF (CHARGE) och sedan till läget CAMERA igen. Using the built-in light You can use the built-in light to suit your shooting situation. The recommended distance between the subject and camcorder is about 1. Press LIGHT until the indicator appears on the screen while your camcorder is in CAMERA mode. If you turn the POWER switch to OFF (CHARGE), the built-in light turns off simultaneously. You cannot turn the built-in light on by turning the POWER switch to CAMERA again. To turn on the built-in light again, press LIGHT again in CAMERA mode. To turn off the built-in light To turn on the built-in light automatically press LIGHT until the indicator appears on the screen. To prevent possible burn hazard, disconnect the power source before replacing and do not touch the bulb until the bulb becomes cool enough to handle (for about 30 minutes or more). Note To prevent the bulb from being smudged with finger prints, handle it with a dry cloth, etc. Connect your camcorder to the VCR using the A/V connecting cable supplied with your camcorder. You can record and edit a picture with the connected VCR by using your camcorder as a player. make the indicators disappear by pressing DISPLAY . If you do not make the indicators disappear, they are recorded on tapes. (1) Insert a blank tape (or a tape you want to record over) into the VCR, and insert the recorded tape into your camcorder. (2) Set the input selector on the VCR to LINE. Refer to the operating instructions of your VCR for more information. (4) Play back the recorded tape on your camcorder. Refer to the operating instructions of your VCR for more information. [. . . ] ­ CCD-TRV49E/TRV59E/TRV78E/TRV98E only To avoid possible damage from battery leakage or corrosion, observe the following: · Be sure to insert the batteries with the + ­ polarities matched to the + ­ marks. Do not use a combination of new and old batteries. Do not use different types of batteries. Current flows from batteries when you are not using them for a long time. [. . . ]