User manual SONY CCD-SP9

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. [. . . ] there are two modes: · Searching for the beginning of a specific date, and playing back from there (Date Search) · Searching for the beginning of all days, one after another and playing back about 10 seconds of each (Date Scan) Each time you press DATE SEARCH, the mode changes as follows: Date Search Date Scan Nothing To search for the beginning of a specific date (3) When the current position is [b], press 0 to search towards [a] or press ) to search towards [c]. To scan the beginning of all days To view pictures during searching or scanning Press · If a day's recording is not longer than 2 minutes, the camcorder may not accurately find its boundaries. Date Search and Date Scan do not function on a tape recorded by a camcorder without the Data Code function. Using the Remote Commander, you can easily go back to the desired point on a tape after playback. The tape stops automatically when the counter reaches approximately zero. Something must be recorded on the tape in order for the tape counter to function. There may be a discrepancy of several seconds from the actual time. This function is cancelled automatically once the tape is rewound or advanced to the point you pre-registered. ZERO MEM does not function during playing back. ZERO MEM does not function when COUNTER is set to TIME CODE in the menu system. If you mark an index signal during recording or playback, you can easily locate the beginning of a desired program later. (2) Press INDEX ERASE on the Remote Commander within 2 to 10 seconds while the desired program plays back. After the index signal is erased, the camcorder returns to index scan or index search mode, whichever was used in step 1. Press INDEX ERASE more than 2 seconds after the playback of the desired program begins. You cannot erase the index signal on a tape with the red mark on the cassette exposed. While the index signal is being erased, the sound cannot be heard and a black band appears at the bottom of the picture. This will not affect the recorded sound or picture. The camcorder can detect index signals marked with VCRs, but may not erase them. VCRs with an index function can detect index signals marked with this camcorder but cannot erase them. An index signal may be erased when making PCM after recording on another VCR in the portion where the index signal is marked. Bars (­) appear in place of the RC time code when the portion is played back. To use that tape for editing using an editing controller (not supplied), rewrite the RC time code. [. . . ] (35 to 280 mm) when converted into a 35 mm still camera) F 1. 7 oz (190 g) Design and specifications are subject to change without notice. When you connect an external microphone, you cannot set WIND in the menu system. , by attaching the ETA-26 Handycam Station adaptor. [. . . ]