User manual SONY CCD-TR40

[. . . ] You will soon be producing home video that you can enjoy for years to come. To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or or BSI to BS1362 (i. [. . . ] When flickering occurs while shooting in the AUTO mode ( ), press LIGHT until the indicator appears. Using the built-in light The built-in light may turn on/off when you use the PROGRAM AE or backlight function while shooting in the AUTO mode ( ). The built-in light may turn off when inserting or ejecting a cassette. While the end search function is working, the built-in light is turned off. When you use the conversion lens (optional), the built-in light is blocked and may not illuminate the subject properly. Remove the power source before replacing the bulb. (1) Remove the built-in light unit while pushing the hole under the built-in light unit using a wire. (2) Turn the bulb housing anticlockwise and detach from the built-in light unit. (4) Attach the bulb housing by turning it clockwise, then replace the built-in light unit. Be sure to align the tab with the groove when inserting. Using the built-in light CAUTION When replacing the bulb, use only the Sony XB-3D halogen lamp (optional) to reduce the risk of fire. When you connect a video camera recorder, set its power switch to VTR/ VCR. 2 Turn the SEL/PUSH EXEC dial to select the IR SETUP code of your VCR, then press the dial. About the IR SETUP code The IR SETUP code is stored in the memory of your camcorder. Be sure to set the correct code depending on your VCR. Brand/ pa-e Sony Aiwa Akai Alba Amstrad Baird Blaupunkt Bush CGM Clatronic Daewoo Ferguson Fisher Funai Goldstar Goodmans Grundig Hitachi ITT/Nokia Instant JVC Kendo Loewe Luxor Mark Matsui Mitsubishi * TV/VCR component Note on IR SETUP code The Easy Dubbing is not possible if the VCR does not support IR SETUP codes. (3) Setting your camcorder and the VCR to face each other Locate the Infrared rays emitter of your camcorder and face it towards the remote sensor of the VCR. ) apart, and remove any obstacles between the devices. 1 Insert a recordable tape into the VCR, then set to recording pause. When finished, the indicator changes to COMPLETE. When the VCR does not operate correctly · Place your camcorder at least 30 cm (12 in. You can select title, colour, size, and background colour. [. . . ] ­ When there are fingerprints on the lens surface ­ In hot or humid locations ­ When the lens is used in environments susceptible to salt such as the seaside · Store the lens in a well-ventilated location subject to little dirt or dust. to prevent mold from growing on the lens , periodically perform the above. We recommend turning on and operating your camcorder at least once per month to keep your camcorder in an optimum state for a long time. To prevent an accidental short circuit, do not allow metal objects to come into contact with the battery terminals. [. . . ]