User manual SONY CD-CMA01

[. . . ] · To prevent short-circuiting, disconnect the negative car battery terminal until the unit has been mounted and connected completely. · When replacing the fuse, be sure to use one whose amperage rating is identical. Use of a fuse of higher amperage may cause serious damage to the unit. · Do NOT attempt to disassemble this unit. [. . . ] Since the RDS signals are in digital data form, you cannot hear them. This means you can receive FM programs without being disturbed by RDS data signals. This unit can receive the following types of RDS digital data; Station name Displaying the station name If the received station has a program service name, the station name is displayed. · The station name may not be displayed if the signal strength is below a certain level. ·PS (Program Service) name Displays the station name during reception. Receiving alternative frequencies When the FM program tuned in is being broadcast on network stations, you can continue to listen to that program when driving long distances without frequent manual retuning. ·AF (Alternative Frequencies) Automatic tuning to alternative frequencies. ·TP (Traffic Program) Automatic traffic announcement reception in a mode other than MW or LW reception mode. ·PTY (Program Type) Program selection by program type, such as news or sports, rather than by station. During FM reception, press AF to turn on the AF indicator. · If the station tuned in does not offer AF data, the AF indicator blinks. The unit searches for an alternative frequency that has the stronger signal among the network stations and immediately retunes to that frequency. 88. 5MHz 90. 1MHz ·EON (Enhanced Other Network) Switches automatically when a traffic announcement begins on another network. Press AF, and the information is updated automatically. ·CT (Clock Time) Adjusts the clock time automatically. To use the CT service, press AF holding TA pressed. When "CT" appears on the display, rotate the Jog Dial to select "CT ON" to start the service or "CT OFF" to stop the service. When the unit successfully receives the service signal, the CT indicator lights, and the clock is adjusted automatically. While the indication is turned on, rotate the Jog Dial to display the desired program type as follows. 1 NEWS 2 AFFAIRS 3 INFO 4 SPORT 5 EDUCATE 6 DRAMA 7 CULTURE 8 SCIENCE 9 VARIED 0 POP M !ROCK M @ EASY M # LIGHT M $ CLASSICS % OTHER M 4. When the desired program type is displayed, press and hold one of the preset station buttons (1 to 6) for more than 2 seconds. The program type is assigned to that button. 2. While the indicator is turned on, press the appropriate preset station button. The table below shows the initial assignment of the preset station buttons to the program types. Preset station button 1 2 3 4 5 6 Program type NEWS SPORT EDUCATE SCIENCE ROCK M CLASSICS 3. While the indicator is turned on, press and hold the appropriate preset station button for more than 0. 5 seconds. A station of selected type is searched, and the reception starts automatically if it is found. Using Auto Memory with RDS In RDS mode you can access the stations you preset with the automatic presetting (Auto Memory) function (see page 6). With the unit in RDS mode, press and hold A. ME/PS for more than 2 seconds. [. . . ] · Do NOT install the remote control unit on the outer rim of the steering wheel. Doing so may hinder steering and cause a traffic accident. Be sure to install the remote control unit on the inner rim of the steering wheel. CAUTION Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user's right or authority to operate this product. Supplied mounting kit The letters below are keyed to those in the instructions. Use only the supplied mounting hardware for safe and secure installation. [. . . ]