User manual SONY CD-CX145

[. . . ] -- Consult the dealer or an experienced radio/ TV technician for help. PRECAUTIONS This unit is designed to be operated on a 12-volt DC negative-ground electrical system only. q To prevent short-circuiting, disconnect the negative car battery terminal until the unit has been mounted and connected completely. q When replacing the fuse, be sure to use one whose amperage rating is identical. Use of a fuse of higher amperage may cause serious damage to the unit. [. . . ] Csre must be taken not to drop the panel. When the front panel ie lifted from the unit, remove it by pulling swsyfrom the unit. LED lamp 3 `1 Do NOT touch the connector on the reverse side of the front panel, as doing so may contaminate the connector and cause a poor connection resulting in a malfunction. ENGLISH 4 SETTING THE CLOCK RADIO OPERATION 1 2 Press PWR to turn the unit on. Press snd hold DISP for more than 2 seconds. 2 1 2 Press PWR to turn the unit on. Press BAND to seiect the band from among FM1, FM2, FM3, AMI, and AM2. The band indication appears cyclically in order. FM1, FM2and FM3sharethesamefrequency range. AMI and AM2 share the same frequency range. 3 4 Press A Press ~ to set the hour. The clock starts working from O second. Havingthe clock dispiayedwhiie the unit is turned on Press DISP. The clock display appears for a few minutes, then the unit returns to its former diapiay. Bsnd indication Frequsncyindiceiion 3 Press (more than 0. 5 second) either TUNE A or TUNE V to tune in the desired station. Press A to increase and V to decrease the frequency. The unit startescanning and tunes in a station automatically (Seek tuning). Press the button again to deactivate the function. Repeat the procedure until the desired station is tuned in. Note If you press (less than 0. 5 second at a time) eitherTUNE A orTUNE V, the frequency decreases or increases step by step. 4 Press VOL to project out the control and turn it to i- or - to atijust the volume. 5 ENGLISH To turn the unit off Press PWR. NOW PRESETTING STATIONS 1 23 Press PWR to turn the unit on. Press BAND to select a desired bend from among FMI, FM2, FM3, AM1, and AM2. ~ 3 Preaa and hold A. ME for more than 2 seconds to activate the automatic presetting function. This unit can store up to 6 stations in memory for preset station button 1 to 6 with LOCAL indicator lights up. If the unit could not search for all of 6 stations, LOCAL indicator goes off andstartssearching for weaker stations again. Use this function to automatically preset up to 6 stations each for FMI, FM2, FM3, AM1, and AM2 (up to a total of 30 stations). q When auto memory is completed, the preset stetions are automatically scanned in order. q To stop auto memory, press A. ME again. TrJcheck the preset stations (preset scan) If you wish to check the preset stations, press A. ME forlessthan2seconds. [. . . ] q Smaller 3-inch (8 cm) CDs cannot be played on this unit. And do not use an adaptor as it may cause malfunctioning. q The CD play atarfs from the first track on the disc. ImOml ENGLISH 8 CD PLAY SOUNDADJUSTMENTS 223 Press REPEAT during CD play. The''REPEAT" indicator lights upandthecurrently selected track is played repeatedly. [. . . ]