User manual SONY CD-CX15

[. . . ] 10 CD PLAYBACK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 PROGRAM PLAY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 SETTING THE CLOCK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 CD CHANGER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Decreases the level of the rear speakers. Note · Without selecting any mode with MOD/LD, only the volume level can be adjusted by pressing + or -. LOUD (loudness) function Press MOD/LD for more than 1. 5 seconds to reinforce bass and treble especially when listening at low volume level. To cancel the loudness, press MOD/LD for more than 1. 5 seconds again. To set the turn-on volume level The unit can be set to always turn on at the same volume level. After adjusting the volume with + or -, press and hold PWR down for more than 2 seconds until a beep tone is heard. EN 7 RADIO OPERATION 1 Press any button (except %) to turn on the unit. The radio frequency is displayed. If the radio frequency is not displayed, press FUNC to select the radio operation. 1 2 Press BAND to select the desired band from FM1, FM2, FM3, and AM. The band indicator [FM1, FM2, FM3, or AM] is displayed. 2 3 Press TUNE M/N repeatedly to tune in the desired station. Press N to increase and M to decrease the frequency. To change the frequency rapidly, press and hold N or M down longer. 3 4 Adjust the volume with + or -. 4 EN 8 Note · FM1, FM2, and FM3 have the same frequency range. · ST indicator lights up when an FM stereo broadcast is received with a sufficient signal strength. Seek Tuning The seek function is used to search for the station automatically. 1 Press BAND to select the desired band. 2 Press SEEK r/t to start the seek function. Press t to search for the higher frequencies and r for the lower frequencies. The seeking stops when the nearest station with good reception is tuned in. Press t or r repeatedly until the desired station is received. To turn off the radio Press FUNC or insert a disc. The radio is turned off and the CD operation starts. EN 9 PRESETTING STATIONS Up to 6 stations for each band [FM1, FM2, FM3, and AM] can be stored on the preset station buttons. 1 Press BAND to select the band from FM1, FM2, FM3, and AM. 1 2 Tune in the station to be preset. 2 3 Press one of the preset station buttons (1 ­ 6) for more than 2 seconds until a beep tone is heard. The number of the pressed preset station button is displayed. ST 3 4 Repeat steps 2 and 3 to preset other stations. Note · As FM1, FM2, and FM3 have the same frequency range, up to 18 stations can be preset for FM. · When a station is preset on the preset station button on which another station of the same band has already been preset, the previously preset station is automatically erased. EN 10 Automatic Presetting The automatic presetting function is used to automatically preset up to 6 stations for each band. 2 Press and hold A. M down for more than 2 seconds until a beep tone is heard. The scanning starts from the currently displayed frequency to higher frequencies and stops when 6 stations have been preset or the receivable frequencies have been scanned once. Note · The presetting is not performed if there is no station to be tuned in. · When the automatic presetting is performed, the previously preset stations are automatically erased. · To stop the automatic presetting, press A. M again or press any of the preset station buttons (1 ­ 6). To scan the preset stations Press A. M for less than 1 second. Each preset station is tuned in for 5 seconds in order. To stop the scanning, press A. M again or any of the preset station buttons (1 ­ 6). To tune in the preset stations Press BAND to select the band and press the preset station button (1 ­ 6). The number of the preset station button is displayed and the preset station is received. EN 11 CD PLAYBACK Press any button (except %) to turn on the unit. 1 Insert a disc with the labeled side up to start playback. If a disc is already inserted, press FUNC to select the CD operation. DISC indicator lights up, and the track number and elapsed playing time are displayed. 2 Adjust the volume with + or - . Press these buttons to operate CD playback. The track number and elapsed playing time flash on and off. [. . . ] Check that the discs are loaded properly into the disc magazine (right side up, etc. ) Reset the unit by pressing the reset button. If this does not correct the problem, consult an AIWA service center. Allow the changer to cool off by moving the vehicle out of direct sunlight. E--2 E--3 E--4 Problem with the compact disc changer. E--5 The compact disc changer is overheated. Reset button The reset button is visible when you detach the control panel. Try pressing this button if a connected compact disc changer does not operate properly. [. . . ]