User manual SONY CD-CX2250

[. . . ] 2 RADIO OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CD PLAYER OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 AUXILIARY EQUIPMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 OTHER FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] VOL (volume) indicator flashes. Muting the sound 1 Press PWR/MUTE briefly. MUTE indicator flashes. To restore volume, briefly press PWR/MUTE again. ENGLISH 2 Adjusting sound You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/ rear) and H-BASS (high bass). Setting the clock 1 Press and hold DISP until the clock indicator flashes in the display. 2 Press i (to set hour) or k (to set minute), and then turn AUDIO CONTROL. 3 Press DISP. 1 Press SEL repeatedly to select the mode to be adjusted. The selected mode's indicator flashes. 2 Turn AUDIO CONTROL to increase/decrease the level or to select on/off for the selected mode. Displaying the clock 1 Press DISP. To return to the former display, press DISP again. Note Adjust the level or select on/off within 5 seconds, or the selected mode will return to previous state. RADIO OPERATION Tuning in to a station (Seek/Manual Tuning) LO Aligning the source levels (Source Level Adjuster) Volume may vary each time you change the source mode. In this case, you can align each source mode's volume to almost the same level. 1 Press SRC or BAND repeatedly to select the desired mode. "LA 0" appears in the display. 3 Turn AUDIO CONTROL to adjust the level. i/k BAND Stereo indicator Local indicator Note Adjust the level within 5 seconds, or the selected mode will be canceled. Restoring the factory settings Band indicator Frequency indication 1 Turn off the unit. 2 Press and hold DISP until "LA --" appears in the display. 1 Press BAND repeatedly to select the desired band (FM1, FM2, FM3, AM1, or AM2). 2* Press i (to move to higher frequencies) or k (to Note You can restore the factory settings only for VOL, BASS, TRE, BAL, FAD, and H-BASS, and aligned source volume levels. move to lower frequencies) to tune in to a station. "ST" appears in the display when FM station is broadcasting in stereo, and receiving conditions are good. *Seek Tuning and Manual Tuning · Press and hold i or k until seek Tuning starts. The unit locates a station automatically (Seek Tuning). · Press i or k repeatedly to search for a desired station while increasing or decreasing the frequency step by step (Manual Tuning). To stop Seek Tuning, press i or k again. Muting button beep sounds 1 Turn off the unit. [. . . ] The unit cannot play such discs. SRC AUX jack 1 Connect a cassette/MD/MP3 portable player or other equipment to the unit's AUX jack (3. 5 mm dia. ). 2 Press SRC repeatedly until "AUX" appears in the display. During AUX mode, the clock display appears. 5 ENGLISH OTHER FUNCTIONS SEL INSTALLATION AND CONNECTIONS OF SPEAKERS Supplied mounting hardware for installation AUDIO CONTROL SRC The letters are keyed to those in the instructions. a Speaker cord × 2 b Screw (4 × 25 mm) × 8 Changing the key illumination color You can choose blue or red as the key illumination color. 1 Press and hold SRC until "ILL" appears in the display. [. . . ]