User manual SONY CD-CX227

[. . . ] · Keep the volume at a level at which you can hear outside warning sounds (horns, sirens, etc. ). TABLE OF CONTENTS THEFT PROTECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 BASIC OPERATION, AUDIO AND CLOCK ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 RADIO OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CD PLAYER OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] However, NEVER use a CD-R or CD-RW that contains no data or data in the wrong format, such as MP3 or other computer files. 2 Press i or k to select "DE". 3 Turn AUDIO CONTROL to select "DE 0. " To resume DEMO mode, select "DE 1" in step 3. 1 ENGLISH THEFT PROTECTION Take the front panel with you when leaving the car, and keep it in the supplied carrying case. BASIC OPERATION, AUDIO AND CLOCK ADJUSTMENT PWR/MUTE SEL AUDIO CONTROL Detaching the front panel Before detaching the front panel, remove the CD to prevent possible damage to the unit. 1 Press z to remove the CD. 2 Press and hold PWR/MUTE until the unit turns off. (Hold the panel with one hand to prevent accidentally dropping it. ) 4 Remove the panel. DISP SRC i/k BAND Turning the unit on/off · Press PWR/MUTE to turn on the unit. The unit also turns on when you insert a CD. · Press and hold PWR/MUTE until the unit turns off. Note Attaching the front panel 1 Engage the left side of the front panel to the left catch on the unit. Most operations described in this manual require the unit to be turned on before starting the operation, unless explicitly stated otherwise. Changing the source mode 1 Press SRC. Pressing SRC cycles through source modes in the following order: 2 Push the panel forward until it locks. Be sure not to press any buttons while you are attaching the panel. ENGLISH FM1 (FM2/FM3/AM1/AM2) CD* AUX * "CD" does not appear in the display when there is no CD in the unit. Adjusting the volume 1 Turn AUDIO CONTROL. Note Do not touch the connector on the reverse side of the front panel. This could cause a poor or faulty connection. VOL (volume) indicator flashes. Muting the sound 1 Press PWR/MUTE briefly. MUTE indicator flashes. To restore volume, briefly press PWR/MUTE again. ENGLISH 2 Adjusting sound You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/ rear) and H-BASS (high bass). Setting the clock 1 Press and hold DISP until the clock indicator flashes in the display. 2 Press i (to set hour) or k (to set minute), and then turn AUDIO CONTROL. 3 Press DISP. 1 Press SEL repeatedly to select the mode to be adjusted. The selected mode's indicator flashes. 2 Turn AUDIO CONTROL to increase/decrease the level or to select on/off for the selected mode. Displaying the clock 1 Press DISP. To return to the former display, press DISP again. Note Adjust the level or select on/off within 5 seconds, or the selected mode will return to previous state. RADIO OPERATION Tuning in to a station (Seek/Manual Tuning) LO Aligning the source levels (Source Level Adjuster) Volume may vary each time you change the source mode. In this case, you can align each source mode's volume to almost the same level. 1 Press SRC or BAND repeatedly to select the desired mode. "LA 0" appears in the display. [. . . ] A newly inserted CD starts from the first track. · A CD-R or CD-RW may take some time to start playing back, but this is not a malfunction. · If a CD-R or CD-RW with no data or incompatible data is inserted, "E03" will appear in the display. The unit cannot play such discs. 2 Press SRC repeatedly until "AUX" appears in the display. [. . . ]