User manual SONY CDP-311

[. . . ] The following icons are used in this manual: Indicates that you can do the task using the remote. This equipment is intended for home entertainment purposes only. The warranty shall be invalidated if used in commercial environments, such as by disc jockeys, etc. Check that you received the following items: · Size AA (LR6) batteries (3) How to use the CD booklet holder the CD booklet holder helps you locate discs easily. [. . . ] All tracks of another disc(s) Other tracks on the same disc Other tracks on other discs Each time you press this button, the display shows the disc and track number of each step in the programmed order. (When a whole disc is programmed as one step, "ALL" appears instead of the track number. ) After the last step in the program, the display shows "­ END ­" and returns to the original display. You can change your program before you start playing. to You need to Press CHECK until the track or disc you don't want appears in the display, then press CLEAR Press CLEAR. Each time you press the button, the last programmed track or disc will be cleared. The programs remain even after Program Play ends when you push the JOG dial or press · In Program Play mode, you can play the same program again. Add tracks or discs to the Follow the programming procedure end of the program Change the whole program completely Hold down CLEAR until "CLEAR" appears in the display to erase the whole program, then create a new program following the programming procedure When you press PROGRAM to select Program Play during Continuous or Shuffle Play Even if you replace discs, the programmed disc and track numbers remain. Therefore, the player will play the new existing disc and track numbers. However, the programed disc and track numbers that are not found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. Press PROGRAM repeatedly in the stop mode until the program number (PROGRAM 1, 2, or 3) you want to erase appears in the display. If the player fails in loading, the following message appears. Press one of the play mode buttons to select the desired play mode. When the set time comes, the player turns on and starts playing. After you have used the timer, set TIMER on the player to OFF. The program you create using the remote is stored in the player as PROGRAM 1. Note that the PROGRAM 1 you had created before is erased. This unit can control a second CD player (see "Connecting Another CD Player" on page 9). Even when a second CD player is connected, the controls on both of the units will function. When you press the play button on either unit, the operating player stops and the idle player starts. Make sure "2nd DETECTED" appears in this player's display after turning on both players. Note that, depending on the player, you may not be able to operate all the functions of the second CD player. [. . . ] Place the player in a location with adequate ventilation to prevent heat build-up in the player. Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. [. . . ]