User manual SONY CDP-470

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. [. . . ] When you find the disc you want, press · to start playing. 1 Press EX-CHANGE. The disc tray opens and two disc compartments appear. Even if the player is playing a disc, it doesn't stop playing. Replace discs in the compartments with new ones. The player plays the disc on the left side compartment after the current disc, and then the one on the right side compartment. The disc tray turns and other two disc compartments appear. Replace discs in the compartments with new ones. 0/) (CDP-470 only) MUSIC SCAN Number buttons >10 · =/+ 0/) To locate The next or succeeding tracks You need to Turn AMS ± clockwise until you find the track. When using the remote, press + repeatedly until you find the track. Turn AMS ± counterclockwise until you find the track. When using the remote, press = repeatedly until you find the track. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that aren't found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. 1 TRACK 2 3 4 STEP 5 2 A 5 8 1 5 3 Programmed tracks After one second Note The total playing time doesn't appear when: --You have programmed a track whose number exceeds 20. --The total playing time of the program exceeds 200 minutes. PROGRAM DISC 1 TRACK 2 3 MIN 4 5 SEC 2 A 5 8 1 5 13 18 Checking the track order You can check your program before or after you start playing. Each time you press this button, the display shows the track (the disc and track numbers) or the disc (the disc number and "AL" indication) of each step in the programmed order. After the last step in the program, the display shows "End" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. Total playing time If you've made a mistake Press CLEAR, then repeat Steps 3 and 4. 5 To program other discs or tracks, do the following: To program Other discs Other tracks on the same disc Other tracks on other discs Repeat Step(s) 2 3 and 4 2 through 4 6 Press · to start Program Play. Changing the track order You can change your program before you start playing. To You need to Press CHECK until the track you don't want appears in the display, then press CLEAR Press CLEAR. Each time you press the button, the last track will be cleared. Follow Steps 2 through 4 of the programming procedure Hold down CLEAR until "ALL CLr" appears in the display. Create a new program following the programming procedure. To cancel Program Play Press CONTINUE. You can create your program while checking the disc labels While the disc tray is open, follow Steps 1 to 6 with pressing the DISC SKIP button to check the disc labels. If you close the disc tray before Step 6, the total playing time appears in the display after a while. [. . . ] · Do not use any commercially available stabilizer. If you do, the disc and the player may be damaged. · After playing, store the disc in its case. On placement · Place the player in a location with adequate ventilation to prevent heat build-up in the player. · Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. [. . . ]