User manual SONY CDP-491

[. . . ] If you do, the speakers may be damaged when a peak level portion is played. Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent such as alcohol or benzine. Before operating the player, check that the operating voltage of the player is identical with your local power supply. [. . . ] push AMS ± to select the language. "READING TEXT" appears momentarily, then the display shows the new selected language. Press TIME/TEXT (or TIME on the remote) repeatedly until the information you want to check appears (see page 8). You can quickly locate any track while playing a disc using the AMS (Automatic Music Sensor) on the player or number buttons on the remote. You can also locate a particular point in a track while playing a disc. If your CD TEXT disc is not equipped with other languages, "CAN'T SELECT" appears in the display when you press the LANGUAGE button. ⷠIf you press LANGUAGE while playing a CD TEXT disc, the current operating language appears momentarily. ⷠThe operating language you have selected remains until you turn off the power. Each time you press DISPLAY ON/OFF on the remote while playing a disc, the display turns off and on alternately. Even when the display is turned off, the display turns on if you pause or stop play. When you resume play, the display turns off again. The player plays this specific portion repeatedly. The indication appears while the player is "shuffling" the tracks. Setting a new starting point You can move the repeating portion ahead by changing the starting point. 1 Press A ­ B while the player is repeating the specific portion. The player repeats between the new starting and ending points. When you want to restart from the starting point A You can start Shuffle Play while playing You can arrange the order of the tracks on a disc and create your own programme. CDP-XE530 Last programmed track Total playing time Playing order After one second CLEAR AMS ± If you've made a mistake Press PLAY MODE repeatedly until "PROGRAM" appers in the display before you start playing. Turn AMS ± until the track number you want appears in the display. Repeat Steps 2 and 3 to programme the tracks in the order you want. CDP-XE530 Total playing time Playing order Track number being programmed When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. The programme remains until erased (see page 13) or until you press §OPEN/CLOSE ⷠCDP-491 Track number being Total playing time programmed The programme you have created remains even after the Programme Play mode ends or you select another play mode. [. . . ] You can freely specify the playing time The fading time is reset to 5 seconds when you turn off the player. ⷠIf you press FADER during Music Scan (page 10), fading time changes to 2 seconds. You can change discs during Time Fade If the play ends before the specified fade-out time, (for example, when you record CD-singles on a tape) you can change the disc. You can fade in to resume playing in Step 4 You can have the player fade out automatically by specifying the playing time. [. . . ]