User manual SONY CDP-720

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] You can play all tracks on all discs in a random order. The indication appears while the player is "shuffling" the tracks. The player repeats the discs/tracks as follows: When the disc is played in You can start Shuffle Play while playing You can specify discs during Shuffle Play (Select Shuffle Play) You can specify discs before or during ALL DISCS Shuffle Play, and the tracks on the specified discs are played in a random order. press DISC 1 ­ 5 to specify the discs after Step 1. Semi-circles appear around the specified disc numbers in the display. You can repeat only the current track while the disc is played in Continuous Play. While the track you want is being played, press REPEAT repeatedly until "REPEAT 1" appears in the display. You can play all tracks on the specific disc in a random order. The indication appears while the player is "shuffling" the tracks. You can have the player "shuffle" tracks and play in a random order. The player shuffles all the tracks on all discs or on the disc you've specified. ) After the last step in the program, the display shows "­END­" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. Press one of the play mode buttons to select the play mode you want. When the set time comes, the player turns on and starts playing. After you have used the timer, set TIMER on the player to OFF. You can record the program you've created on a tape, DAT or MD. the program can contain up to 32 tracks. By inserting a pause during programming, you can divide the program into two for recording on both sides of a tape. You can manually fade in or out to prevent tracks from starting or ending abruptly. Note that you cannot use this effect when you use the DIGITAL OUT (OPTICAL) connector. Create your program (for side A when recording on a tape) while checking the total playing time indicated in the display. [. . . ] To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠShould the AC power cord (mains lead) need to be changed, have it done at a qualified service shop only. not this way · Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. ⷠDo not use any commercially available stabilizer and/or disc protector. [. . . ]