User manual SONY CDP-CA9ES

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The indication appears while the player is "shuffling" the tracks. You can have the player "shuffle" tracks and play in a random order. The player shuffles all the tracks on all discs or on the disc you've specified. You can start Shuffle Play while playing You can arrange the order of the tracks on the discs and create your own program. When you want to program the whole disc as one step, skip Step 3 and go to Step 4. Press the number buttons of the tracks you want to program in the order you want. To program the track numbered over 10 (or 20 when using the remote), use the >10 button (or >20 on the remote) (see page 9). Last programmed track Playing order After one second If you've made a mistake RM-D515 for CDP-CA8ES Press CLEAR on the remote, then press the correct number button. Other discs Other tracks on the same disc Other tracks on other discs If a program is already stored, the last step of the program appears in the display. When you want to erase the whole program, hold down CLEAR on the remote until "ALL CLEAR" appears in the display (see page 12). You can create your program while checking the disc labels While the disc tray is open, follow Steps 1 to 5 with pressing DISC SKIP to check the disc labels. If you close the disc tray before Step 5, the total playing time appears in the display after a while. Note that, if the programmed track number isn't found on the disc, that step is automatically erased. You can change your program before you start playing. Press CHECK until the track or disc you don't want appears in the display, then press CLEAR Press CLEAR. Each time you press the button, the last track or disc will be cleared. Follow Steps 2 to 4 in "Creating Your Own Program" on page 11 Hold down CLEAR until "ALL CLEAR" appears in the display to erase the whole program, then create a new program following Steps 2 to 4 in "Creating Your Own Program" on page 11 The program remains even after the Program Play ends When you press (, you can play the same program again. Erase the last step in the program Add steps to the end of the program Change the whole program completely If you replace discs, the programmed disc and track numbers remain. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that aren't found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. The total playing time doesn't appear when: --You have programmed a track whose number exceeds 20. You can start playing a disc at any time you want by connecting a timer (not supplied). [. . . ] If you do, the disc and the player may be damaged. â· After playing, store the disc in its case. Before playing, clean the disc with a cleaning cloth. Place the player in a location with adequate ventilation to prevent heat build-up in the player. [. . . ]