User manual SONY CDP-CE315

[. . . ] Any difference in operation is clearly indicated in the text, for example, "CDP-CE335 only. You can also use the controls on the remote if they have the same or similar names as those on the player. ⷠThe following icons are used in this manual: Indicates that you can do the task using the remote. (Note that the CDP-CE315 cannot do the tasks marked with this icon. [. . . ] ⷠDo not push the disc tray to close it in Step 5, as you may damage the player. ⷠWhen you press the DISC CHECK button, the play mode automatically changes to ALL DISCS Continuous Play mode. ⷠWhen you've opened the disc tray by pressing the EX-CHANGE button, you cannot use the DISC CHECK function. ⷠEven if you press the DISC CHECK button while "REPEAT" appears in the display (see page 11), the player stops after scanning all the discs once. You can quickly locate any track while playing a disc using the AMS (Automatic Music Sensor) control or number buttons on the remote. You can also locate a specific point in a track while playing a disc. When you directly locate a track numbered over 10 (CDP-CE335 only) Z Press >10 first, then the corresponding number buttons on the remote. To enter "0, " use button 10/0. Example: To play track number 30 Press >10 first, then 3 and 10/0. You can extend the playing time during Music Scan Press MUSIC SCAN repeatedly until the playing time you want (10, 20 or 30) appears in the display. Each time you press the button, the playing time changes cyclically. You can start Shuffle Play while playing If a program is already stored, the last step of the program appears in the display. When you want to erase the whole program, hold down CLEAR until "ALL CLr" appears in the display (see page 13). When you want to program the whole disc as one step, skip Steps 3 to 4, and go to Step 5. Turn AMS ± until the track number you want appears in the display. The track number being programmed flashes and the total playing time including the track appears in the display. Track number being programmed The program remains until you erase it or turn off the player If you replace discs, the programmed disc and track numbers remain. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that aren't found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. After one second The total playing time doesn't appear when: --You have programmed a track whose number exceeds 20. You can check your program before or after you start playing. Each time you press this button, the display shows the track (the disc and track numbers) or the disc (the disc number and "AL" indication) of each step in the programmed order. [. . . ] To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠAC power cord must be changed only at the qualified service shop. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. ⷠDo not use any commercially available stabilizer. [. . . ]