User manual SONY CDP-CE515

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Before operating the unit, please read this manual thoroughly and retain it for future reference. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. [. . . ] Follow the programming procedure Hold down CLEAR until "ALL CLEAR" appears in the display. Create a new program following the programming procedure. Erase the last track in the program Add tracks to the end of the program Change the whole program completely You can select a track directly using the number buttons Press the number button of the track in Step 5. To select a track numbered over 10, use the >10 button (see page 13). You can create your program while checking the disc labels While the disc tray is open, follow Steps 1 to 8 with pressing the DISC SKIP button to check the disc labels. If you close the disc tray before Step 8, the total playing time appears in the display after a while. Note that, if the programmed track number isn't found on the disc, that step is automatically erased. The total playing time doesn't appear when: --You have programmed a track whose number exceeds 20. This unit can control a second CD player (see "Connecting Another CD Player" on pages 6 and 7). Even when a second CD player is connected, the controls on both of the units will function. When you press the play button on either unit, the operating player stops and the resting player starts. The controls indicated in the illustration below are effective while the MEGA CONTROL button is lit. Pause Stop play Locate a disc while the second player is set to Continuous Play mode Locate a track AMS Turn (DISC) ± until the display shows the disc number you want, then push AMS (DISC) ± Press 0 (­AMS+) ) until the display shows the track number you want To do other operations, use the controls on the second player or the supplied remote. ⷠThe AMS buttons (=/+) and search buttons (0/)) on the remote operate the second player as indicated on the remote. To control the second player directly using the supplied remote Set CD 1/2/3 on the remote to CD 3 which is the same position as the COMMAND MODE selector on the rear panel of the second player. The MEGA CONTROL button lights up and the display shows the current disc number of the second player. To control this player again press MEGA CONTROL. The MEGA CONTROL button goes off and you can control this player. You cannot locate a particular point in a track of the second player using the controls on this player. ⷠSome controls on this player work on the second player differently from they do to this player. To program tracks, use the controls on the second player. The play starts and the display shows the current disc and track numbers and the playing time of the track. [. . . ] If you do, the disc and the player may be damaged. ⷠAfter playing, store the disc in its case. Place the player in a location with adequate ventilation to prevent heat build-up in the player. ⷠDo not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. [. . . ]