User manual SONY CDP-CE525

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Before operating the unit, please read this manual thoroughly and retain it for future reference. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. [. . . ] You can change your program before you start playing. to Erase a track The controls indicated in the illustration below are effective while the MEGA CONTROL button is lit. Press CHECK until the track you don't want appears in the display, then press CLEAR Press CLEAR. Each time you press the button, the last track will be cleared. Follow the programming procedure Hold down CLEAR until "CLEAR" appears in the display. Create a new program following the programming procedure. Erase the last track in the program Add tracks to the end of the program Erase the whole program completely Playing discs of the second CD player 1 press MEGA CONTROL. The MEGA CONTROL button lights up and the display shows the current disc number of the second player. To program tracks, use the controls on the second player. The play starts and the display shows the current disc and track numbers and the playing time of the track. While the MEGA CONTROL button is lit, you can control the second player with the controls on this player as follows: Pause Stop play Locate a disc while the second player is set to Continuous Play mode Locate a track AMS Turn (DISC) ± until the display shows the disc number you want, then push AMS (DISC) ± This player starts loading. If each Disc Memo of the second CD player has more than 12 characters, the first 12 characters of each are loaded to this player. Press 0 (­AMS+) ) until the display shows the track number you want Labeling discs of the second CD player You can label discs of the second CD player or change the Disc Memos loaded from the second CD player. To do other operations, use the controls on the second player or the supplied remote. ⷠThe AMS buttons (=/+) and search buttons (0/)) on the remote operate the second player as indicated on the remote. AMS Turn (DISC) ± to select the disc you want, AMS then push (DISC) ±. To control the second player directly using the supplied remote Set CD 1/2/3 on the remote to CD 3 which is the same position as the COMMAND MODE selector on the rear panel of the second player. AMS Turn (DISC) ± until " DISC MEMO" AMS appears in the display, then push (DISC) ±. To control this player again press MEGA CONTROL. The MEGA CONTROL button goes off and you can control this player. You cannot locate a particular point in a track of the second player using the controls on this player. ⷠSome controls on this player work on the second player differently from they do to this player. [. . . ] If you do, the disc and the player may be damaged. ⷠAfter playing, store the disc in its case. Place the player in a location with adequate ventilation to prevent heat build-up in the player. ⷠDo not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. [. . . ]