User manual SONY CDP-CE575

[. . . ] This Class A digital apparatus complies with Canadian ICES-003. You can also use the controls on the remote if they have the same or similar names as those on the player. Using the Player with Another Component This section describes how to hook up the CD player to an amplifier. Be sure to turn off the power of each component before making the connections. [. . . ] Completely Create a new program following the programming procedure. You can manually fade in or out to prevent tracks from starting or ending abruptly. Note that you cannot use this effect when you use the DIGITAL OUT (OPTICAL) connector. Each time you press these buttons, the display changes as shown below, with the tape length of one side following each indication. End play fading out When you want to start fading out. Then play fades out and the player pauses. 5 When you record on both sides of the The player inserts a pause, then creates the program for side B. the display shows the programmed tracks. When you record on one side of the tape, skip this step. H or X on the player to resume playing the remaining tracks. The player locates the highest level among the tracks to be recorded to let you adjust the recording level before you start recording. 1 Before you start playing, press PEAK You can program the tracks you want in advance. Create a program selecting the desired tracks, then follow Steps 2 to 7. Be careful that the total playing time of the program does not exceed the tape length of one side. â· You can set the tape length freely using l AMS L. Example: When the tape length of one side is 30 minutes and 15 seconds 1 To set the minutes, turn l AMS L until "30" appears in the display, then push l AMS L. 2 To set the seconds, turn l AMS L until "15" appears in the display, then push l AMS L. If you have made a mistake while inputting the character To correct the character which has been input 1 Press m or M until the incorrect character flashes. 2 Turn l AMS L until the desired character appears. To correct the character currently being input Each time you press the button, the letter changes cyclically among the ones indicated beside the button. To input symbols, press the number button 1 repeatedly until the symbol you want appears in the display. To input a number, press the number button you want. [. . . ] Should this occur, the player may not operate properly. In this case, remove the disc and leave the player turned on for about an hour until the moisture evaporates. Do not turn up the volume while listening to a portion with very low level inputs or no audio signals. If you do, the speakers may be damaged when a peak level portion is played. [. . . ]