User manual SONY CDP-CX153

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] You can play discs/tracks repeatedly in any play mode. Each time you press SHUFFLE, "ALL DISCS" or "1 DISC" appears in the display. The player repeats the discs/tracks as follows: When the disc is played in All tracks on all discs in a randam order All tracks on the specific disc in a randam order When you want to specify the disc for 1 DISC Shuffle Play, turn the JOG dial until the disc number or Disc Memo (see page 18) you want appears in the display. " " appears in the display while the player is "shuffling" the discs or the tracks. You can start Shuffle Play while playing You can repeat only the current track. While the track you want is being played, press REPEAT repeatedly until "REPEAT 1" appears in the display. You can go to the next disc during 1 DISC Shuffle Play You can arrange the order of the tracks and/or discs and create 3 different programs and programs are stored automatically. A program can contain up to 32 "steps" -- one "step" may contain a track or a whole disc. The programs are stored in the player`s memory for about a month with the power turned off. You can make programs using the controls on the remote as well as ones on the player. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that are not found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. To program a whole disc, skip this step and go to Step 6. To select a track with a number over 10 Press the 10's digit first, then the 1's digit. To enter 0, use the button 10/0 (see page 10). You can check your program before or after you start playing. Other discs Other tracks on the same disc Other tracks on other discs Each time you press this button, the display shows the disc and track number of each step in the programmed order. (When a whole disc is programmed as one step, "AL" appears instead of the track number. ) After the last step in the program, the display shows "END" and returns to the original display. You can change your program before you start playing. to You need to Press CHECK until the track or disc you do not want appears in the display, then press CLEAR. Each time you press the button, the last track or disc will be cleared. [. . . ] Should this occur, the player may not operate properly. In this case, leave the player turned on for about an hour until the moisture evaporates. Do not turn up the volume while listening to a portion with very low level inputs or no audio signals. If you do, the speakers may be damaged when a peak level portion is played. [. . . ]