User manual SONY CDP-CX210

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Before operating the unit, please read this manual thoroughly and retain it for future reference. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. [. . . ] the disc comes to the loading position. Remove the disc after the rotary table comes to a complete stop. Make sure you have inserted the discs correctly as indicated on page 6. You can play all the tracks on a disc in the original order (Continuous Play). You can also play up to 200 discs consecutively. Turn on the amplifier and select the CD player position. Each time you press CONTINUE, "ALL DISCS" or "1 DISC" appears in the display. You can turn on the player by pressing POWER on the remote Z All discs in the player consecutively in the order of disc number. Only one disc you have selected Turn the JOG dial until the disc number you want appears in the display to select the first disc (ALL DISCS) or the disc you want (1 DISC). When you turn off the player by pressing the POWER switch (standby mode) The player remembers the last playing disc and the play mode (Continuous, Shuffle (see page 12) or Program (see page 13)). When you turn on the player again, therefore, the player plays the same disc in the same play mode. Note that the player does not remember this information, if you turn off the player by pressing the power switch of the amplifier or receiver while the AC power cord is connected to the switched AC outlet of the amplifier or receiver. The selected disc is set to the playing position, and the player plays all the discs from the selected one (ALL DISCS) or all the tracks once (1 DISC). While playing a disc, the display shows the current disc number, track number, playing time of the track and the next disc number. Next disc number Playing time of the track Pause Resume playing after pause Go to the next disc Go back to the preceding disc Go to the next track Go back to the preceding track Stop playing and remove the disc You can specify the next disc to play while playing a disc in Continuous or 1 DISC Shuffle Play mode. While playing a disc, turn the JOG dial until the disc number you want appears in the display. Next disc number After the current disc is played, the next disc you have specified starts playing. If you want to skip to the next disc right away, press ENTER while playing the current disc. Turn the JOG dial until the disc number you want appears in the display. Example: To enter number 35 Press 3, then 5. To enter number 100 Press 1, then 0 twice. You can quickly locate any track while playing a disc using the /± (AMS: Automatic Music Sensor) buttons or number buttons on the remote. [. . . ] Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. After removing a disc from the disc slot, store the disc in its case. [. . . ]