User manual SONY CDP-CX240

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] Follow the programming procedure Hold down CLEAR until "CLEAR" appears in the display to erase the whole program, then create a new program following the programming procedure Erase the last track or disc in the program Add tracks or discs to the end of the program Change the whole program completely Press PROGRAM repeatedly in the stop mode until the program number (PROGRAM 1, 2 or 3) you want to erase appears in the display. Hold down CLEAR until "CLEAR" appears in the display. This unit can control a second CD player (see "Connecting Another CD Player" on page 6). Even when a second CD player is connected, the controls on both of the units will function. When you press the play button on either unit, the operating player stops and the resting player starts. Make sure "2nd DETECTED" appears in this player's display after turning on both players. Note that depending on the player, you may not be able to operate all the functions of the second CD player. The controls indicated in the illustration below are effective while the MEGA CONTROL button is lit. The display shows the current disc number or disc memo of the second player. To program tracks, use the controls on the second player. You cannot change the second CD player's ALL DISCS Play mode to 1 DISC Play mode, and vice versa, by using the play mode button on this player. The play starts and the display shows the current disc and track numbers and the playing time of the track. While the MEGA CONTROL button is lit, you can control the second player with the controls on this player. To control the second player directly using the supplied remote Set CD 1/2/3 on the remote to CD 3 which is the same position as the COMMAND MODE selector on the rear panel of the second player. To control this player again press MEGA CONTROL. The MEGA CONTROL button goes off and you can control this player. Loading the Disc Memos of the second CD player If the second CD player has the Disc Memo function (see page 23), you can load the Disc Memos of the second CD player to this player's memory and display them on this player. Turn the JOG dial until "LOAD 2ND MEMO" appears in the display. You can manually fade the sound in or out to prevent tracks from starting or ending abruptly. Note that you cannot use this effect when you use the DIGITAL OUT (OPTICAL) connector. If each Disc Memo of the second CD player has more than 13 characters, the first 13 characters of each are loaded to this player. Labeling discs of the second CD player You can label discs of the second CD player or change the Disc Memos loaded from the second CD player. [. . . ] Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. After removing a disc from the disc slot, store the disc in its case. Place the player in a location with adequate ventilation to prevent heat build-up in the player. Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. [. . . ]