User manual SONY CDP-CX300

[. . . ] Any difference in operation is clearly indicated in the text, for example, "CDP-CX240 only. The following caution label is located inside of the unit. You can also use the controls on the remote if they have the same or similar names as those on the player. The following icons are used in this manual: Indicates that you can do the task using the remote. [. . . ] You can change your program before you start playing. Press CHECK until the track or disc you do not want appears in the display, then press CLEAR Press CLEAR. Each time you press the button, the last track or disc will be cleared. Follow the programming procedure Hold down CLEAR until "CLEAR" appears in the display to erase the whole program, then create a new program following the programming procedure Erase the last track or disc in the program Add tracks or discs to the end of the program Erase the whole program completely Press PROGRAM repeatedly in the stop mode until the program number (PROGRAM 1, 2 or 3) you want to erase appears in the display. Hold down CLEAR until "CLEAR" appears in the display. This unit can control a second CD player (see "Connecting Another CD Player" on page 6). Even when a second CD player is connected, the controls on both of the units will function. When you press the play button on either unit, the operating player stops and the resting player starts. Make sure "2nd DETECTED" appears in this player's display after turning on both players. Note that depending on the player, you may not be able to operate all the functions of the second CD player. The controls indicated in the illustration below are effective while the MEGA CONTROL button is lit. The other player skips the lead-in portion and starts playing from where the sound actually begins. X-Fade Play: The current player changes at each track or at the specified interval. You can select the interval among 30, 60 and 90 seconds. Each time the current player changes to the other player, the sound from both players is mixed. The current player ends play by fading out, and the other player starts play by fading in. The MEGA CONTROL button lights up while the track in the second player is selected. Press the corresponding button repeatedly until "NO DELAY" or "X-FADE" disappears from the display. You can change the method (No-Delay or X-Fade) during play You can start X-Fade whenever you like press FADER during X-Fade Play. Even after you have set the X-Fade mode and started XFade play, you can start X-Fade manually at any point you like. Note that you cannot do this operation while the sound from both players is mixed. The play starts from the second player if you start play while the MEGA CONTROL button is lit. [. . . ] After removing a disc from the disc slot, store the disc in its case. Place the player in a location with adequate ventilation to prevent heat build-up in the player. Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. [. . . ]