User manual SONY CDP-CX55

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] You cannot specify the next disc to play during ALL DISCS Shuffle Play. Even if you press p or turn off the player during ALL DISCS Shuffle Play, the player remembers which discs/ tracks were played and which were not. Therefore, if you want to start ALL DISCS Shuffle Play again from the beginning, be sure to repeat the procedure from Step 1. To program a whole disc, skip this step. Press /± until the track number you want appears in the display. You can arrange the order of the tracks and/or discs to create three different programs and programs are stored automatically. Each program (PROGRAM 1, 2 or 3) can contain up to 32 "steps" -- one "step" may contain a track or a whole disc. You can make programs using the controls on the remote as well as ones on the player. However, the programming procedures are different. Other discs Other tracks on the same disc Other tracks on other discs The programs remain even after Program Play ends when you press · , you can play the same program again. To program a whole disc, skip this step and go to Step 6. When you press PROGRAM during Continuous or Shuffle Play The programs remain until you erase them If you replace discs, the programmed disc and track numbers remain. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that are not found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. The number you pressed is entered into the flashing digit. Press PROGRAM until the program number you want (PROGRAM 1, 2 or 3) appears in the display. Other tracks on other discs You can check your program before or after you start playing. Each time you press this button, the display shows the disc and track number of each step in the programmed order. (When a whole disc is programmed as one step, "ALL" appears instead of the track number. ) After the last step in the program, the display shows "END" and returns to the original display. You can change your program before you start playing. Press and hold LOOP during playback at the point you want to start the Loop function, and release to resume normal play. [. . . ] After removing a disc from the disc slot, store the disc in its case. Place the player in a location with adequate ventilation to prevent heat build-up in the player. Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. [. . . ]