User manual SONY CDP-CX555ES

[. . . ] The following icons are used in this manual: Indicates that you can do the task using the remote. The following caution label is located inside of the unit. This equipment is intended for home entertainment purposes only. The warranty shall be invalidated if used in commercial environments, such as by disc jockeys, etc. [. . . ] When you press PROGRAM during Continuous or Shuffle Play The programs remain until you erase them If you replace discs, the programmed disc and track numbers remain. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that are not found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. To program a whole disc, skip this step. Press /± until the track number you want appears in the front panel display. When connected to the second player, you can program tracks/discs of both players in the same program When selecting a disc, press PLAYER SELECT repeatedly until "2nd PLAYER" appears in the front panel display. Then select the disc you want to program. Other discs Other tracks on the same disc Other tracks on other discs Press PROGRAM until the program number you want (PROGRAM 1, 2 or 3) appears in the front panel display. You can check your program before or after you start playing. Each time you press this button, the front panel display shows the disc and track numbers of each step in the programmed order. (When a whole disc is programmed as one step, "ALL" appears instead of the track number. If you have a Sony receiver (amplifier) with the onscreen display control function, you can control the player using the remote supplied with the receiver (amplifier). You can start playing a disc at any time you want by connecting a timer (not supplied). Connect the player to the VIDEO jack on the receiver (amplifier), and register the IR code of the jack to which this player is connected as "CONTROL A1/CD2. " Click LIST on the on-screen display using the remote supplied with the receiver (amplifier). The on-screen display changes to the CD player information display. For details on this function, refer to the instructions supplied with the receiver (amplifier). Press one of the play mode buttons to select the play mode you want. When the set time comes, the player turns on and starts playing. After you are finished using the timer, set TIMER on the player to OFF. When the CD player information display does not fit inside the receiver's (amplifier's) on-screen display control panel, adjust the position using the GRAPHIC POSITION function on the receiver (amplifier). The CD player information display may return to the receiver (amplifier) information display while playing discs, depending on the connected receiver (amplifier). [. . . ] If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the player. Should this occur, the player may not operate properly. In this case, leave the player turned on for about an hour until the moisture evaporates. Do not turn up the volume while listening to a portion with very low level inputs or no audio signals. [. . . ]