User manual SONY CDP-CX57

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] All tracks of another disc(s) Other tracks on the same disc Other tracks on other discs Hold down CLEAR until "CLEAR" appears in the display. When you insert a disc into the PLUS ONE slot, you can play the disc independently from other discs. The play mode you have selected (except for Program Play) remains active even if you use this function. You can check your program before or after you start playing. Each time you press this button, the display shows the disc and track number of each step in the programmed order. (When a whole disc is programmed as one step, "ALL" appears instead of the track number. ) After the last step in the program, the display shows "­ END ­" and returns to the original display. You can change your program before you start playing. Press CHECK until the track or disc you do not want appears in the display, then press CLEAR Press CLEAR. Each time you press the button, the last track or disc will be cleared. Follow the programming procedure Hold down CLEAR until "CLEAR" appears in the display to erase the whole program, then create a new program following the programming procedure Erase the last track or disc in the program Add tracks or discs to the end of the program Change the whole program completely Close the front cover. "P1" appears in the display instead of the disc number, and the player starts playing the disc in the PLUS ONE slot. This unit can control a second CD player (see "Connecting Another CD Player" on page 6). Even when a second CD player is connected, the controls on both of the units will function. When you press the play button on either unit, the operating player stops and the resting player starts. Make sure "2nd DETECTED" appears in this player's display after turning on both players. Note that depending on the player, you may not be able to operate all the functions of the second CD player. The controls indicated in the illustration below are effective while the MEGA CONTROL button is lit. The disc number in the display changes to 51 and you can play the disc as the 51st disc. If you have already inserted a disc into the PLUS ONE slot Press PLUS ONE while the front cover is closed. You can change the play mode by pressing the PLAY MODE button before Step 4 Plus One Play will be canceled if you turn the JOG dial or press buttons to specify another disc. The PLUS ONE slot comes to the loading position automatically if you open the front cover during Plus One Play. [. . . ] Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. After removing a disc from the disc slot, store the disc in its case. [. . . ]