User manual SONY CDP-M27

[. . . ] Notes on the power supply lead (yellow) · When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. When no car circuits are rated high enough, connect the unit directly to the battery. Be sure to connect the ground lead before connecting the amplifier. If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. [. . . ] If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated. First connect the black ground lead, then connect the yellow and red power input leads. 2 To the power antenna control lead or power supply lead of antenna booster amplifier Notes · It is not necessary to connect this lead if there is no power antenna or antenna booster, or with a manually-operated telescopic antenna. When your car has a built-in FM/AM antenna in the rear/side glass, see "Notes on the control and power supply leads. " 3 To AMP REMOTE IN of an optional power amplifier This connection is only for amplifiers. Connecting any other system may damage the unit. 4 To the +12 V power terminal which is energized in the accessory position of the ignition key switch Notes · If there is no accessory position, connect to the +12 V power (battery) terminal which is energized at all times. Be sure to connect the black ground lead to a metal surface of the car first. When your car has a built-in FM/AM antenna in the rear/side glass, see "Notes on the control and power supply leads. " 5 To the +12 V power terminal which is energized at all times Be sure to connect the black ground lead to a metal surface of the car first. In this case, make sure the speaker and amplifier are connected correctly. Existing parts supplied with your car Pièces existantes fournies avec la voiture Existing parts supplied with your car Pièces existantes fournies avec la voiture Choose the installation location carefully so that the unit will not interfere with normal driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. How to detach and attach the front panel (7) Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF). Attach part A of the front panel to part B of the unit as illustrated and push the left side into position until it clicks. Before installing the unit, remove the protection collar 3 and the bracket 1 from the unit. 1 Engage the release keys 5 together with the protection collar 3. 2 Pull out the release keys 5 to remove the protection collar 3. [. . . ] 1 Engage the release keys 5 together with the protection collar 3. 2 Pull out the release keys 5 to remove the protection collar 3. 1 Insert both release keys 5 together between the unit and the bracket 1 until they click. 2 Pull down the bracket 1, then pull up the unit to separate. [. . . ]