User manual SONY CDP-XA50ES

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Before operating the unit, please read this manual thoroughly and retain it for future reference. The instructions in this manual are for models CDP-XA50ES and CDP-XA30ES. [. . . ] The track numbers disappear from the music calendar after "OFF" appears for a while. To delete a track numbered over 10, use the >10 button (see page 11). If you've made a mistake Each time you press programme the button, the last track will be cleared. Add tracks to the end of Turn AMS ± until track the programme number you want to add appears, then push AMS ±. When using the remote, press the number button of the tracks to be added. Change the whole programme completely Hold down CLEAR until "ALL CLr" appears in the display. Create a new programme following the programming procedure. After you've deleted all the tracks you don't want, press CONTINUE. "SHUFFLE" disappears from the display. If you press PLAY MODE on the player instead of CONTINUE on the remote the deleted tracks will be restored. Be sure to do this step with the remote. You can delete unwanted tracks and play only the remaining tracks. The player keeps the deleted tracks in memory even after the Delete Play ends when you press · , you can play only the remaining tracks again. You can play the tracks in random order (Delete Shuffle Play) You can delete a track while playing Press CLEAR while the track is being played. The player deletes the track and starts playing the next track. You can store the deleted tracks of each disc You can record the programme you've created on a tape, DAT or MD. the programme can contain up to 24 tracks. By inserting a pause during programming, you can divide the programme into two for recording on both sides of a tape. Create your programme (for side A when recording on a tape) while checking the total playing time indicated in the display. see "Creating Your Own Programme" on page 14. When you record on both sides of the tape, press to insert a pause. " When you record on one side of the tape or on a DAT or MD, skip this step and go to Step 4. [. . . ] Place the player in a location with adequate ventilation to prevent heat build-up in the player. Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. [. . . ]