User manual SONY CDP-315

[. . . ] Do not connect either wire to the earth terminal in the plug which is marked by the letter E or by the safety earth symbol Y or coloured green or green-and-yellow. If you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠAC power cord must be changed only at the qualified service shop. [. . . ] While playing a disc, the display shows the current track number, playing time and the music calendar. The track numbers in the music calendar disappear after they are played. Each time you press TIME while playing a disc, the display changes as shown in the chart below. Checking the total number and playing time of the tracks press TIME before you start playing. The display shows the total number of tracks, total playing time and music calendar. Playing time and number of the current track Press Remaining time on the current track If the track number exceeds 68, "­ ­ . Music calendar Total playing time While in Shuffle Play mode ("SHUFFLE" appears in the display; see page 9), a one-second access time blank is added between each track. This increase is automatically added to the total playing time in the display. The information also appears when you press § OPEN/CLOSE to close the disc tray. You can quickly locate any track while playing a disc using the AMS (Automatic Music Sensor) on the player or number buttons on the remote. You can also locate a particular point in a track while playing a disc. Total playing time Track numbers being programmed You can start Shuffle Play while playing Last programmed track Playing order After one second Press number buttons of the tracks you want to program in the order you want. example: To program the tracks 2 , 8 and 5. Press number buttons in the order 2, 8 and 5. If you've made a mistake Repeat Steps 2 and 3 to program the tracks in the order you want. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. After one second The program remains even after the Program Play ends when you press · , you can play the same program again. To select a track with a number over 10 The total playing time doesn't appear in the display when it exceeds 100 minutes. ⷠ"FULL" appears in the display when you try to add a track to a program which already contains 24 tracks. If you've made a mistake Press CLEAR, then press the correct track number. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. The program remains even after the Program Play ends When you press (, you can play the same program again. [. . . ] Note that tracks whose numbers are over 24 cannot be programmed automatically. Press PLAYMODE until "SHUFFLE" and "PROGRAM" disappear from the display. You can program the tracks you want in advance Select the tracks before doing the above procedure. The player creates a program from the remaining tracks. [. . . ]