User manual SONY CDP-34

[. . . ] The instructions in this manual are for model CDP-34. The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. [. . . ] The program can contain up to 32 "steps" -- one "step" may contain a track or a whole disc. Turn AMS ± until the track number you want appears in the display. The track number being programmed flashes and the total playing time including the track appears in the display. Note that, if the programmed track number isn't found on the disc, that step is automatically erased. Press =/+ until the track number you want appears in the display. The total playing time doesn't appear when: --You have programmed a track whose number exceeds 20. Track number being programmed You can check your program before or after you start playing. Each time you press this button, the display shows the track (the disc and track numbers) or the disc (the disc number and "AL" indication) of each step in the programmed order. After the last step in the program, the display shows "END" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. This unit can control a second CD player (see "Connecting Another CD Player" on pages 6 and 7). The MEGA CONTROL button goes off and you can control this player. You cannot locate a particular point in a track of the second player using the controls on this player. ⷠSome controls on this player work on the second player differently from they do to this player. Input the new Disc Memo following the procedure in "Labeling Discs" on pages 24 to 26. The new Disc Memos are stored on this player's memory, so you cannot display them on the second CD player. Loading the Disc Memos of the second CD player If the second CD player has the Disc Memo function (see page 24), you can load the Disc Memos of the second CD player to this player's memory and display them on this player. Turn AMS ± until "LOADING MEMO" appears in the display. When you connect the second player, you can play tracks in this player and those in the second player alternately in any play mode (see "Connecting Another CD Player" on pages 6 and 7). select one of the following methods: · No-Delay Play: The current player changes at each track. Each time the current player changes to the other player, the other player starts play without a break in sound immediately after the current player ends play. The other player skips the lead-in portion and starts playing from where the sound actually begins. [. . . ] To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠAC power cord must be changed only at the qualified service shop. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. ⷠDo not use any commercially available stabilizer. [. . . ]