User manual SONY CDP-597

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This equipment is intended for home entertainment purposes only. The warranty shall be invalidated if used in commercial environments, such as by disc jockeys, etc. [. . . ] Press /± until the track number you want appears in the display. You cannot specify the next disc to play during ALL DISCS Shuffle Play. Even if you press p or turn off the player during ALL DISCS Shuffle Play, the player remembers which discs/ tracks were played and which were not. Therefore, if you want to start ALL DISCS Shuffle Play again from the beginning, be sure to repeat the procedure from Step 1. All tracks of another disc(s) Other tracks on the same disc Other tracks on other discs The programs remain even after Program Play ends when you push the JOG dial or press · , you can play the same program again. When you press PLAY MODE to select Program Play during Continuous or Shuffle Play The program remains until you erase them Even if you replace discs, the programmed disc and track numbers remain. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that are not found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. If you press the PLUS ONE button during Program Play, Program Play will be canceled (see page 19). The number you pressed is entered into the flashing digit. When the disc has more than 10 tracks, press 0 first then press the corresponding number to enter a track number from 1 to 9. Do not put your hand inside the compartment nor change the disc before the rotary table comes to a complete stop. If you do, you may injure your hand or damage the disc. The display shows the current disc number or disc memo of the second player. If each Disc Memo of the second CD player has more than 13 characters, the first 13 characters of each are loaded to this player. Labeling discs of the second CD player You can label discs of the second CD player or change the Disc Memos loaded from the second CD player. Press PLAY MODE to select the play mode you want. To program tracks, use the controls on the second player. You cannot change the second CD player's ALL DISCS Play mode to 1 DISC Play mode, and vice versa, by using the PLAY MODE button on this player. The play starts and the display shows the current disc and track numbers and the playing time of the track. While the MEGA CONTROL button is lit, you can control the second player with the controls on this player. Turn the JOG dial to select the disc you want to assign a Disc Memo to, then push the JOG dial. [. . . ] If you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. AC power cord must be changed only at the qualified service shop. Place the player in a location with adequate ventilation to prevent heat build-up in the player. [. . . ]