User manual SONY CDP-620ES

[. . . ] If you do, the speakers may be damaged when a peak level portion is played. Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. Before operating the player, check that the operating voltage of the player is identical with your local power supply. [. . . ] The display shows the total number of tracks, total playing time and music calendar. Playing time and number of the current track Press Remaining time on the current track Music calendar Total playing time Remaining time on the disc While in Shuffle Play mode ("SHUFFLE" appears in the display; see page 9), a one-second access time blank is added between each track. This increase is automatically added to the total playing time in the display. The information also appears when you press § OPEN/CLOSE to close the disc tray. You can quickly locate any track while playing a disc using the AMS (Automatic Music Sensor) on the player or number buttons on the remote. You can also locate a particular point in a track while playing a disc. When you directly locate a track numbered over 10 when using the remote (except for CDP-620ES) Press >10 first, then the corresponding number buttons. Example: To play track number 30 Press >10 first, then 3 and 10. You can extend the playing time during Music Scan Press MUSIC SCAN repeatedly until the playing time you want (10, 20 or 30) appears in the display. Each time you press the button, the playing time changes cyclically. You can play tracks repeatedly in any play mode. After one second The program remains even after the Program Play ends when you press · , you can play the same program again. To select a track with a number over 10 The total playing time doesn't appear in the display when it exceeds 100 minutes. ⷠ"FULL" appears in the display when you try to add a track to a program which already contains 24 tracks. If you've made a mistake Press CLEAR, then press the correct track number. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. The program remains even after the Program Play ends When you press (, you can play the same program again. You can record the program you've created on a tape, DAT or MD. the program can contain up to 24 tracks. By inserting a pause during programming, you can divide the program into two for recording on both sides of a tape. You can check the total playing time while programming using the remote (Program Edit) To select a track, press = or + and check the total playing time. Then press PROGRAM to confirm your selection. [. . . ] You can have the player create a program that will fit the length of the tape. The player automatically creates a program, keeping the original order of the disc. The program can contain up to 24 tracks (a pause inserted between tracks is counted as one track). Note that tracks whose numbers are over 24 cannot be programmed automatically. [. . . ]