User manual SONY CDP-C100

[. . . ] The instructions in this manual are for model CDP-C100. The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. [. . . ] When you want to erase the whole program, hold down CLEAR until "CLEAR" appears in the display (see page 18). All tracks on other discs Other tracks on the same disc Other tracks on other discs The program you create remains in memory even if you stop the Program Play. After the last step in the program, the display shows "END" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. This unit can control a second CD player (see "Connecting Another CD Player" on pages 6 and 7). Even when a second CD player is connected, the controls on both of the units will function. When you press the play button on either unit, the operating player stops and the resting player starts. Note that depending on the player, you may not be able to operate all the functions of the second CD player. The controls indicated in the illustration below are effective while the MEGA CONTROL button is lit. You can change your program before you start playing. Press CHECK until the track you don't want appears in the display, then press CLEAR. When you connect the second player, you can play tracks in this player and those in the second player alternately in any play mode (see "Connecting Another CD Player" on pages 6 and 7). select one of the following methods: · No-Delay Play: The current player changes at each track. Each time the current player changes to the other player, the other player starts play without a break in sound immediately after the current player ends play. The other player skips the lead-in portion and starts playing from where the sound actually begins. ⷠX-Fade Play: The current player changes at each track or at the specified interval. You can select the interval among 30, 60 and 90 seconds. Each time the current player changes to the other player, the sound from both players is mixed. The current player ends play by fading out, and the other player starts play by fading in. The MEGA CONTROL button lights up while the track in the second player is selected. Press the corresponding button repeatedly until the button goes off. You can change the method (No-Delay or X-Fade) during play You can start X-Fade whenever you like press FADER during X-Fade Play. [. . . ] To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠAC power cord must be changed only at the qualified service shop. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. ⷠDo not use any commercially available stabilizer. [. . . ]