User manual SONY CDP-C515

[. . . ] · Do not use screws other than the supplied screws for installation. · Do not install the unit following any procedure other than that explained in this manual. Make sure to follow the procedure in this manual closely. This may cause a malfunction of the unit or cause injury to you. [. . . ] The unit may be damaged or fall, causing injury to you. 5 If you connect IR OUT of the Unit and IR IN of a component, such as a DVD Changer, you can operate the DVD Changer with the remote (supplied with the DVD Changer) by aiming it at the Unit. Place the mounting bracket over the hole so that the preconstruction bracket and the mounting bracket match across the wall. Then fasten the wall mounting bracket screws carefully to fix the mounting bracket and preconstruction bracket so that they are level and align perfectly. Make sure the larger tab is mounted at the bottom. · The Unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if the player itself has been turned off. · If you are not going to use the Unit for a long time, be sure to disconnect the Unit from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord. Connecting an AC power unit After connecting the Unit and the AC power unit using the power supply cables, connect the AC power cord to the AC IN of the AC power unit, then the other end of the AC power cord to the wall outlet. Notes Larger tab Unpacking Item CDP-C515 Unit DVP-NW50 Unit Remote commander (remote) (RM-ANU001 ) Wall mounting bracket Wall stopper TEMPLATE Plug-in 4P terminal (for speakers) Plug-in 5P terminal (for AC power unit) Plug-in 6P terminal (for AC power unit) Screws for fixing the Unit to the wall mounting bracket (short) Screws for wall stopper (long) AM loop antenna (aerial) R6 (size-AA) battery User's manual Installer's manual (this manual) CDP-C515/DVP-NW50 System Network CDP-C515 1 ­ 1 1 4 1 1 1 ­ 4 4 1 2 1 1 · Fasten the screws securely. Failure to fasten the screws or incomplete tightening of the screws may cause the Unit to fall and cause an accident. · For mounting the bracket, use the supplied screws. Installing the Unit Before installing the Unit into the wall, take steps to ensure your safety and that of your surroundings, then check the following: · The location of the power source to make sure that power supply cable can reach from the Unit. · The location of the speakers to make sure that speaker cords can be run between the Unit and the speakers. · The distance between the Unit and the AC power unit (up to 200 feet (60 m)). · The durability of the wall (The thickness of the wall must be between 1/2 to 3/4 inches. · There are no obstructions, such as an air, an electrical, or a water conduit near the location where the Unit is installed. 8 SPEAKERS (DVP-NW50) a) SUB WOOFER/CENTER Connects a sub woofer and a center speaker using a speaker cable . b) SUR R/SUR L Connects surround speakers using speaker cables. c) FRONT R/FRONT L Connects front speakers using speaker cables. Other hookup 9 DC IN for the CDP-C515/ 0 DC IN for the DVP-NW50 Connects the DC IN connector using the power supply cables inserted to connect the AC power unit and a Unit. Mounting the Unit into the wall Before connecting the cords and cables, make sure of the following: · Cords and cables to be connected to the Unit reach to the Unit location. · Turn off all of the components before making any connections. · Do not connect the AC power cords until all of the connections are completed. · Be sure to make connections firmly to avoid hum and noise. Notes · Under normal conditions, the batteries should last for about six months. When the remote no longer operates the player, replace both batteries with new ones. · Do not leave the remote in an extremely hot or a humid place. · Do not drop any foreign object into the remote casing, particularly when replacing the batteries. · Do not use a new battery with an old one. [. . . ] SP. DISTANCE (speaker distance) 3 Fix the Unit onto the wall with the screws at the four points as shown below. LEVEL (DVD-NW50 only) S. WOOFER FRONT CENTER SURROUND L SURROUND R DIMMER (CVD-NW10 only) DRC (DVD-NW50 only) OFF OFF OFF OFF OFF Both OFF OFF OFF AC-NW50 AC power unit for DVP-NW50 (front) (optional) Speaker connector for CDP-C515/DVP-NW50 Be sure to match the speaker cables to the appropriate terminal on the connector: + to + and ­ to ­. If a cable is reversed, the sound may be distorted. Before connecting the AC power cord of the AC power unit to a wall outlet, connect all parts of the system to the Unit. Note DC IN connector for the CDP-C515/DVP-NW50 Use Sony's connecting cables for the required connections of the Unit and AC power unit. CDP-C515 After completing all the connections, make sure there are no misconnections or improper wiring before plugging the Unit into the wall outlet. Improper wiring or mis-connections may cause the Unit to be damaged. 1 (cable color) To the Black Yellow Blue Red A B C D Connect the GND 14V GND 29. 5V Then, to the DC IN/OUT 9 / qa 9 / qa 9 / qa 9 / qa Make sure all the power supply cables are inserted into the proper DC IN/OUT connector. [. . . ]