User manual SONY CDP-C705

[. . . ] The instructions in this manual is for model CDP-C705. You can also use the controls on the remote if they have the same or similar names as those on the player. The following icons are used in this manual: Indicates that you can do the task using the remote. To prevent fire, do not cover the ventilation of the apparatus with news papers, table-cloths, curtains, etc. [. . . ] This unit can control a second CD player (see "Connecting Another CD Player" on page 6). Even when a second CD player is connected, the controls on both of the units will function. When you press the play button on either unit, the operating player stops and the resting player starts. Make sure "2nd DETECTED" appears in this player's display after turning on both players. Note that depending on the player, you may not be able to operate all the functions of the second CD player. The controls indicated in the illustration below are effective while the MEGA CONTROL button is lit. The display shows the current disc number or disc memo of the second player. To program tracks, use the controls on the second player. While the MEGA CONTROL button is lit, you can control the second player with the controls on this player. To control the master player again press MEGA CONTROL. The MEGA CONTROL button goes off and you can control the master player. You can change the method (No-Delay or X-Fade) during play You can start X-Fade at any point of the track press FADER during X-Fade Play. Even after you have set the X-Fade mode and started X-Fade play, you can start X-Fade manually at any point you like. Note that you cannot do this operation while the sound from both players is mixed. The play starts from the second player if you start play while the MEGA CONTROL button is lit. When one player has played all the discs/tracks in the player ahead of the other player, the play stops. Do not use the controls on the second player during No-Delay/X-Fade Play. Select the play mode you want on each player. Each time you press the X-FADE button, the indication appears as follows: n X-FADE off n at track end n after 30 sec after 90 sec N after 60 sec N To change the current player each time a whole track is finished, select "at track end. " To change the current player at the specified interval, press X-FADE repeatedly until the interval you want appears in the display. When you connect the player to a Sony MD deck compatible with the Mega Control function or operate a Sony MD deck by using the computer software like "MD Editor, " you must set the player as shown below: Turn the JOG dial until "CONTROL A1 ?After following steps 1 and 2, and "CONTROL A1 displayed, then press YES. [. . . ] Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. Before playing, clean the disc with a cleaning cloth. If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the player. [. . . ]