User manual SONY CDP-C745

[. . . ] Place the player in a location with adequate ventilation to prevent heat build-up in the player. ⷠDo not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. ⷠDo not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the player. [. . . ] If you aren't familiar with how to play CDs, go to the section "Playing a CD" on page 6. Then, go to the following sections for other operations. If you turn on the player with a CD in the tray You can start playing automatically from the beginning of the CD. If you connect a commercially available timer, you can start playing the CD at any time you want. Turn on the amplifier and select the CD player position so that you can listen to the sound from this player. If play doesn't start from the first track Press CONTINUE. The disc tray closes and the player plays all the tracks once (Continuous Play). Pause Resume play after pause Go to the next track Go back to the preceding track Stop play and remove the CD You can check information about the disc using the display. While playing a disc, the display shows the current track number, playing time and the music calender. The track numbers in the music calendar disappear after they are played. Each time you press TIME while playing a disc, the display changes as shown in the chart below. to Press CHECK until the track you don't want appears in the display, then press CLEAR CLEAR. Each time you press the button, the last track will be cleared. Number buttons of the tracks to be added, or repeat Steps 2 to 4 p to erase the whole programme. You can also press CLEAR on the remote until "AL-CLr" appears in the display (for the CDPM305). Then create a new programme following the programming procedure. Erase a track (CDP-M305 only) Erase the last track in the programme (CDP-M305 only) Add tracks to the end of the programme (CDP-M305 only) Change the whole programme completely Repeat Steps 2 and 3 to programme in the order you want. Instead of Steps 2 to 4, press the number buttons of the tracks you want to programme in the order you want. To programme the track numbered over 10, use the >10 button (see page 8). The programme remains even after the Programme Play ends when you press · ((), you can play the same programme again. The total playing time doesn't appear in the display when it exceeds 100 minutes. ⷠ"FULL" appears in the display when you try to add a track to a programme which already contains 24 tracks. [. . . ] / Replace all the batteries in the remote with new ones if they are weak. 6 µW* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up block with 7 mm aperture. 5 dB More than 97 dB More than 90 dB Less than 0. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. [. . . ]