User manual SONY CDP-C7ESD

[. . . ] The instructions in this manual are for models CDP-C7ESD and CDP-C360Z. The CDP-C7ESD is the model used for illustration purposes, unless otherwise mentioned. Any difference in operation is clearly indicated in the text, for example, "CDP-C7ESD only. The model and serial numbers are located at the rear of the unit. [. . . ] When you find the track you want, press · A specific track directly Z A track by scanning each track for 10 seconds (Music Scan) When you directly locate a track numbered over 10 Z Press >10 first, then the corresponding number buttons on the remote. Example: To play track number 30 Press >10 first, then 3 and 10. You can extend the playing time during Music Scan Press MUSIC SCAN repeatedly until the playing time you want (10, 20 or 30) appears in the display. Each time you press the button, the playing time changes cyclically. You can also locate a specific point in a track while playing a disc. You can play discs/tracks repeatedly in any play mode. The player repeats the discs/tracks as follows: When the disc is played in A point while ) (forward) or 0 (backward) and monitoring the sound hold down until you find the point A point quickly by ) (forward) or 0 (backward) and observing the display hold down until you find the point. During pause You will not hear the sound during the operation. Press REPEAT repeatedly until "REPEAT" disappears from the display. You can repeat only the current track while the disc is played in any play mode. While the track you want is being played, press REPEAT repeatedly until "REPEAT 1" appears in the display. However, the disc and track numbers that aren't found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. After one second The total playing time doesn't appear when: --You have programmed a track whose number exceeds 20. Other discs Other tracks on the same disc Other tracks on other discs 2 through 4 5 and 6 2 through 6 You can select a track directly using the number buttons Press the number button of the track in Step 5. To select a track numbered over 10, use the >10 button (see page 12). You can create your program while checking the disc labels While the disc tray is open, follow Steps 1 to 8 with pressing the DISC SKIP button to check the disc labels. If you close the disc tray before Step 8, the total playing time appears in the display after a while. Note that, if the programmed track number isn't found on the disc, that step is automatically erased. When you want to program the whole disc as one step, skip Steps 5 to 6, and go to Step 7. Press =/+ until the track number you want appears in the display. The total playing time doesn't appear when: --You have programmed a track whose number exceeds 20. Track number being programmed You can check your program before or after you start playing. [. . . ] To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠAC power cord must be changed only at the qualified service shop. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. ⷠDo not use any commercially available stabilizer. [. . . ]