User manual SONY CDP-M33

[. . . ] You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. Before operating the unit, please read this manual thoroughly and retain it for future reference. The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. [. . . ] You can play all the tracks on a disc in the original order (Continuous Play). You can also play up to 51 discs consecutively. Turn on the amplifier and select the CD player position. Each time you press CONTINUE, "ALL DISCS" or "1 DISC" appears in the display. All discs in the player consecutively in the order of disc number. Only one disc you have selected Turn the JOG dial until the disc number you want appears in the display to select the first disc (ALL DISCS) or the disc you want (1 DISC). The selected disc is set to the playing position, and the player plays all the discs from the selected one (ALL DISCS) or all the tracks once (1 DISC). While playing a disc, the display shows the current disc number, track number, playing time of the track and the next disc number. Next disc number Playing time of the track Pause Resume playing after pause Go to the next track Go back to the preceding track Stop playing and remove the disc Press )± Press 0 Open the front cover, then push the JOG dial. You can quickly locate any track while playing a disc using the 0/)± (AMS: Automatic Music Sensor) buttons. You can also locate a specific point in a track while playing a disc. If you want to skip to the next disc right away, push the JOG dial while playing the current disc. You cannot specify the next disc to play during ALL DISCS Shuffle Play. If a program is already stored, the last step of the program appears in the display. When you want to erase the whole program, hold down CLEAR until "All Clr" appears in the display (see page 13). Turn the JOG dial until the disc number you want appears in the display. To program a whole disc, skip this step. Press 0/)± until the track number you want appears in the display. You can change your program before you start playing. Press CHECK until the track or disc you do not want appears in the display, then press CLEAR Press CLEAR. Each time you press the button, the last track or disc will be cleared. Follow the programming procedure Hold down CLEAR until "All Clr" appears in the display to erase the whole program, then create a new program following the programming procedure Other discs Other tracks on the same disc Other tracks on other discs Erase the last track or disc in the program Add tracks or discs to the end of the program Change the whole program completely Hold down CLEAR until "All Clr" appears in the display. [. . . ] Before operating the player, check that the operating voltage of the player is identical with your local power supply. The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. If you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. [. . . ]