User manual SONY CDP-X505ES

[. . . ] If you do, the speakers may be damaged when a peak level portion is played. Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. Before operating the player, check that the operating voltage of the player is identical with your local power supply. [. . . ] When you resume play, the display turns off again. Before you start playing, when you press DISPLAY ON/OFF to turn off the display, "dISP OFF" appears, and when you press the button to turn on the display, "dISP On" appears. You can quickly locate any track while playing a disc using the AMS (Automatic Music Sensor) on the player or number buttons on the remote. You can also locate a particular point in a track while playing a disc. When you directly locate a track numbered over 10 when using the remote Press >10 first, then the corresponding number buttons. Example: To play track number 30 Press >10 first, then 3 and 10. You can extend the playing time during Music Scan Press MUSIC SCAN repeatedly until the playing time you want (10, 20 or 30) appears in the display. Each time you press the button, the playing time changes cyclically. You can play tracks repeatedly in any play mode. Turn AMS ± clockwise until you find the track. When using the remote, press + repeatedly until you find the track. ⷠ"FULL" appears in the display when you try to add a track to a programme which already contains 24 tracks. Press PLAY MODE repeatedly until "PROGRAM" appears in the display before you start playing. Turn AMS ± until the track number you want appears in the display. The playing order and the track numbers being programmed are flashing in the display. Press number buttons of the tracks you want to programme in the order you want. example: To programme the tracks 2 , 8 and 5. Press number buttons in the order 2, 8 and 5. Last programmed track Total playing time Track numbers being programmed Last programmed track Total playing time To select a track with a number over 10 If you've made a mistake Press CLEAR, then press the correct track number. If you've made a mistake Repeat Steps 2 and 3 to programme the tracks in the order you want. The programme remains even after the Programme Play ends When you press (, you can play the same programme again. You can record the programme you've created on a tape, DAT or MD. [. . . ] Example: When the tape length of one side is 30 minutes and 15 seconds 1 To set the minutes, turn AMS ± until "30" appears in the display, then press ENTER. 2 To set the seconds, turn AMS ± until "15" appears in the display, then press ENTER. Before you start playing, press PEAK SEARCH. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. [. . . ]