User manual SONY CDP-X777ES

[. . . ] ⷠIf you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. ⷠAC power cord must be changed only at the qualified service shop. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. [. . . ] If the playback of the current disc ends, the player stops playing. If the disc is played in 1 DISC Repeat Play mode (see page 10), the current disc starts playing again. In Programme Play mode (see page 11), only the tracks on the current disc are played. ⷠDo not push the disc tray to close it in Step 5, as you may damage the player. You can quickly locate any track while playing a disc using the /± (AMS: Automatic Music Sensor) buttons or number buttons. You can also locate a specific point in a track while playing a disc. You can locate any disc before or while playing a disc. The next disc A specific disc directly A disc while checking the labels (except for CDPC450Z, CDP-C350Z and CDP-C250Z) DISC SKIP while playing a disc DISC 1 ­ 5 DISC CHECK while the disc tray is open. The disc tray turns to show you each disc label. When the disc you want comes in front of you, press · to start playing. DISC CHECK before you start playing while the disc tray is closed. The indication appears while the player is "shuffling" the tracks. If a program is already stored, the last step of the program appears in the display. When you want to erase the whole program, hold down CLEAR until "ALL CLr" appears in the display (see page 12). You can start Shuffle Play while playing When you want to program the whole disc as one step, skip Step 3 and go to Step 4. Press the number buttons of the tracks you want to program in the order you want. To program the track numbered over 10, use the >10 button (see page 10). After one second If you've made a mistake Press CLEAR, then press the correct number button. Other discs Other tracks on the same disc Other tracks on other discs You can check your program before or after you start playing. Each time you press this button, the display shows the track (the disc and track numbers) or the disc (the disc number and "AL" indication) of each step in the programmed order. After the last step in the program, the display shows "End" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. [. . . ] Press the number buttons to delete the tracks you want to delete. The track number and "OFF" appears in the display and the track numbers you`ve deleted disappear from the music calendar. If you've made a mistake press the number button of the track. The track number and "On" appears in the display and the track will be restored. [. . . ]