User manual SONY CDP-X77ES

[. . . ] Do not connect either wire to the earth terminal in the plug which is marked by the letter E or by the safety earth symbol Y or coloured green or green-and-yellow. Before operating the unit, please read this manual thoroughly and retain it for future reference. The instructions in this manual are for models CDP-CA9ES and CDP-X77ES. The CDP-CA9ES is the model used for illustration purposes, unless otherwise mentioned. [. . . ] You can play discs/tracks repeatedly in any play mode. You can play all tracks on all discs in a random order. The indication appears while the player is "shuffling" the tracks. The player repeats the discs/tracks as follows: When the disc is played in You can start Shuffle Play while playing You can specify discs during Shuffle Play (Select Shuffle Play) You can specify discs before or during ALL DISCS Shuffle Play, and the tracks on the specified discs are played in a random order. press DISC 1 ­ 5 to specify the discs after Step 1. Semi-circles appear around the specified disc numbers in the display. You can repeat only the current track while the disc is played in Continuous Play. While the track you want is being played, press REPEAT repeatedly until "REPEAT 1" appears in the display. You can play all tracks on the specific disc in a random order. The indication appears while the player is "shuffling" the tracks. You can have the player "shuffle" tracks and play in a random order. (When a whole disc is programmed as one step, "AL" appears instead of the track number. ) After the last step in the programme, the display shows "­END­" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. Press one of the play mode buttons to select the play mode you want. When the set time comes, the player turns on and starts playing. After you have used the timer, set TIMER on the player to OFF. You can record the programme you've created on a tape, DAT or MD. the programme can contain up to 32 tracks. By inserting a pause during programming, you can divide the programme into two for recording on both sides of a tape. You can manually fade in or out to prevent tracks from starting or ending abruptly. Note that you cannot use this effect when you use the DIGITAL OUT (OPTICAL) connector. [. . . ] To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. AC power cord must to be changed only at the qualified service shop. not this way · Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be considerable rise in temperature inside the car. Do not use any commercially available stabilizer and/or disc protector. [. . . ]