User manual SONY CDP-XA20ES

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] Total playing time Track numbers being programmed You can start Shuffle Play while playing Press PLAY MODE once (or SHUFFLE on the remote), and Shuffle Play starts from the current track. You can delete unwanted tracks during Shuffle Play (Delete Shuffle Play) Press the number button of the track you want to delete on the remote. The track number and "OFF" appear in the display, and then the track number disappears from the music calendar. If you want to restore the track, press the number button again. To select a track with a number over 10 If you've made a mistake Press CLEAR, then press the correct track number. If you've made a mistake You can check the total playing time while programming using the remote (Program Edit) To select a track, press ` or B and check the total playing time. Then press PROGRAM to confirm your selection. Repeat Steps 2 and 3 to program the tracks in the order you want. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. The program remains even after the Program Play ends When you press ß you can play the same program , again. The program remains even after the Program Play ends When you press 9, you can play the same program again. The total playing time doesn't appear in the display when it exceeds 100 minutes. "FULL" appears in the display when you try to add a track to a program which already contains 24 tracks. The total playing time doesn't appear in the display when it exceeds 100 minutes. "FULL" appears in the display when you try to add a track to a program which already contains 24 tracks. You can check your program before or after you start playing. Each time you press this button, the display shows the track number in the programmed order. After the last track in the program, the display shows "End" and returns to the original display. If you check the order after you start playing, the display shows only the remaining track numbers. Press number buttons of the tracks you want to program in the order you want. Example: To program the tracks 2, 8 and 5 Press number buttons in the order 2, 8 and 5. [. . . ] If you have any questions or problems concerning your player, please consult your nearest Sony dealer. To keep the disc clean, handle the disc by its edge. Place the player in a location with adequate ventilation to prevent heat build-up in the player. Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom. [. . . ]