User manual SONY CDU-711

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] ⷠAvoid exposing the drive to sudden changes in temperature as condensation may form on the lens inside the drive. Should the surrounding temperature suddenly rise while the drive is turned on, stop using the drive and leave the power on at least one hour before operating it or turning it off. Operating the drive immediately after a sudden increase in temperature may result in a malfunction. s Transportation · Close the disc drawer before moving the drive. When you need to ship the drive to another location, repacking it in its original container will help you transport it safely. This section provides an example of instruction for installing the CD-ROM drive unit into your personal computer using the IDE Host Adaptor (A TA-Compliant). Y need the f ollo wing par ts and tools (these are not supplied with ou the drive): · Two mounting rails if your computer has mounting tracks. unplugthecomputeranddisconnectthecablesattachedtotheback to give yourself more room to work. Do not turn on the power of the computer before completing the entire installation process. When the CDU711 is daisy-chained with a Hard Disk Drive on an IDE Card, set the Hard Disk Drive as MASTER and the CDU711 as SLAVE. However, it should be noted that some per sonal computer s ma y use CSEL in lieu of the f oresaid MASTER/SLA VE selection. Consult y our PC man ufacturer , IDE Car d man ufacturer or dealer f or further details. 1 If your computer has its rear side covered by a plastic panel Attached with plastic hook pad, pull it off. Cover mounting screw If mounting rails are necessar y, attac h them to the drive in the same way as your floppy disk drive and slide the drive into the lower drive ba y. If mounting rails are not required in y our system, scre w the drive in place. After matching the beveled edges, insert the plug of the power supply cable to the DC INPUT connector and push it firmly in place. [. . . ] The disc tray has four disc locks that prevent the disc from falling when the drive is set up in vertical position. Note: When the drive is used in horizontal position, you do not need to lock the disc. S Locking and unlocking All of the four locks are set in the unlocked position (facing outwar d) when the drive is shipped fr om the factor y. [. . . ]